COMBI P5: MIDI Filter 5–1: <1> T01–08, 5–2: <1> T09–16
87
COMBI P5: MIDI Filter
These settings allow you to apply filters to the MIDI data
that will be transmitted and received by each timbre 1–16.
For example even if two timbres are being played by the
same MIDI channel, you can make settings so that the
damper pedal will apply to one but not the other.
On (checked): Transmission and reception or reception
(After Touch) of MIDI data is enabled.
If Status (Combi 3–1(2)c) is INT, the effects of the checked
items will be applied to the timbre’s program when the
controllers of the KROME are operated or when MIDI data
is received. (Effect Dynamic Modulation is not affected by
these settings.)
In the case of EXT or EX2, operating a controller on the
KROME will transmit MIDI data on the channel of that
timbre. MIDI transmission/reception settings for the entire
KROME can be made in MIDI Filter (Global 1–2b).
The MIDI Filter <4> and <5> contain MIDI filters for
assignable controllers (whose function can be set by the
user), and if these are assigned to MIDI control changes, the
filter settings will affect those control changes. In this case, if
the same control change has been assigned in MIDI Filter
pages <1>–<3>, the settings in MIDI Filter pages <1> through
<3> will take priority. Also, if the same control change is
assigned to two or more controllers in the MIDI Filter pages
<4> and <5>, checking any one of them will enable that
control change.
Off (unchecked): Transmission and reception of MIDI data
is disabled.
Note: MIDI CC# = MIDI control change message numbers.
5–1: <1> T01–08,
5–2: <1> T09–16
5–1(2)a: Combination Name, Tempo
5–1(2)b: Timbre Info
For more information, please see “2–1: EQ Trim T01–08, 2–2:
EQ Trim T09–16” on page 79.
5–1(2)c: MIDI Filter1
Timbre 01 (Timbre Number):
Enable Program Change [Off, On]
Specifies whether or not MIDI program change messages
will be transmitted and received.
Enable After Touch [Off, On]
Specifies whether or not MIDI after touch messages will be
received.
Enable Damper [Off, On]
Specifies whether or not MIDI CC#64 hold (damper pedal)
messages will be transmitted and received.
Enable Portamento SW [Off, On]
Specifies whether or not MIDI CC#65 portamento on/off
messages will be transmitted and received.
Timbre 02...08, 09...16 (Timbre Number):
These are the MIDI Filter1 settings for timbres 2–8 and 9–16.
They are the same as for timbre 1. For more information,
please see “Timbre 01 (Timbre Number):” above.
V
5–1(2): Menu Command
•0: Write Combination see p. 101
•1: Exclusive Solo see p. 64
•2: Auto Song Setup see p. 65
•3: Copy from Program see p. 101
For more information, please see “Combination: Menu
Command” on page 101.
To Next Page
Loading...
