Korg Krome - Arpeggiator Functionality

Program mode
34
V 3–5: Menu Command
•0: Write Program see p. 64
•1: Exclusive Solo see p. 64
•2: Auto Song Setup see p. 65
•3: Copy Oscillator see p. 65
•4: Swap Oscillator see p. 65
•5: Sync Both EGs see p. 66
For more information, please see “Program: Menu
Command” on page 64.
3–6: Filter2
This page controls Oscillator 2’s basic filter 2 settings. It is
available only when the Oscillator Mode is set to Double or
Double Drums; if not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–1: Filter1” on page 26.
3–7: Filter2 Keyboard Track
This page contains the settings for Oscillator 2’s keyboard
track. Among other things, you can:
• Set up complex keyboard tracking shapes, and control
how the tracking affects filter cutoff.
• Control the effect of the Filter Envelope on filter cutoff.
• Assign AMS modulation for filter cutoff.
Filter B is available when the Filter Routing is set to Serial
or Parallel. Otherwise, the parameters for Filter B will be
grayed out.
3–8: Filter2 Modulation
This page controls Oscillator 2’s filter modulation. It is
available when the Oscillator Mode is set to Double or
Double Drums; if not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–3: Filter1 Modulation” on page 29.
3–9: Filter2 LFO Mod.
This page controls Oscillator 2’s LFO filter modulation. It is
available when the Oscillator Mode is set to Double or
Double Drums; if not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–4: Filter1 LFO Mod.” on page 30.
3–10: Filter2 EG
This page controls Oscillator 2’s Filter EG. It is available
when the Oscillator Mode is set to Double or Double
Drums; if not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–5: Filter1 EG” on page 31.