EQ and Filters (EQ/Filter) 017: Talking Modulator
261
if you do not want to add lower harmonics to the higher
range.
017: Talking Modulator
This effect adds an unusual character, like a human voice, to
the input signal. Modulating the tone via dynamic
modulation, you can create an interesting effect that sounds
as if the guitar or synthesizer is talking.
c: Voice Top
d: Voice Center
e: Voice Bottom
These parameters assign vowels to the top, center, and
bottom position of the controller.
E.g.: When “Voice Top”=A, “Voice Center”=I, and “Voice
Bottom”=U:
If Sweep Mode is set to D‐mod is selected as the modulation
source, moving your finger from the right to left of will
change the sound from “a” to “i,” then “u.”
If Sweep Mode is set to LFO, the sound will change
cyclically from “a” to “i,” “u,” “i,” then “a.”
f: Formant Shift
This parameter adjusts the frequency level to which the
effect is applied. If you wish to apply the effect to a higher‐
range sound, set this parameter to a higher value; to apply
the effect to a lower‐range sound, set this to a lower value.
f: Resonance
This parameter sets the intensity of resonance for the voice
pattern. A larger value will add more character to the sound.
018: Stereo Decimator
This effect creates a rough sound like a cheap sampler by
lowering the sampling frequency and data bit length. You
can also simulate noise unique to a sampler (aliasing).
a Sweep Mode D-mod, LFO
Switches between modulation
source control and LFO control
b
Manual Voice
Control
Bottom,
1...49, Center,
51...99, Top
Voice pattern control
Src Off...Tempo
Selects the modulation source
that controls the voice pattern
c Voice Top A, I, U, E, O
Selects a vowel sound at the top
end of control p.261
d Voice Center A, I, U, E, O
Selects a vowel sound in the
center of control p.261
e Voice Bottom A, I, U, E, O
Selects a vowel sound at the
bottom end of control p.261
f
Formant Shift –100...+100
Sets the frequency to which the
effect is applied p.261
Resonance 0...100
Sets the Level of resonance of
the voice pattern p.261
g
LFO
Frequency
[Hz]
0.02...20.00 Sets the speed of the LFO p.257
Src Off...Tempo
Selects a modulation source for
LFO speed
Amt
–20.00...
+20.00
Sets the modulation amount of
LFO speed
h
MIDI Sync Off, On
When this is on, the LFO speed is
set by BPM, Base Note, and
Times, instead of Frequency
p.257
BPM
MIDI,
40.00...
300.00
MIDI syncs to the system tempo;
40–300 sets the tempo manually
for this individual effect p.257
Base Note ...
Selects the type of notes that
specify the LFO speed p.257
Times x1...x32
Sets the number of notes that
specify the LFO speed p.257
i
LFO Type
Individual,
Common1,
Common2
Selects either (individual) LFO,
Common FX LFO1, or Common
LFO2 p.257
Common
LFO Offset
[deg]
–180...+180
Sets the phase offset when Type
= Common 1 or Common 2
p.257
j
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Right
Wet / Dry
Wet / Dry
+
D
-mod
Voice Top: A
Voice Center: I
Voice Bottom: U
A
-
I
-
U
-
E
-
O
Talking Modulator
LFO
D-mod
LFO
Sweep Mode
a
Pre LPF Off, On
Selects whether the harmonic
noise caused by a decrease in
sampling frequency is generated
or not p.262
High Damp
[%]
0...100
Sets the ratio of cut of the high
range
b
Sampling
Frequency
[Hz]
1.00k...
48.00k
Sets the sampling frequency
Src Off...Tempo
Selects the modulation source of
the sampling frequency
Amt
–48.00k...
+48.00k
Sets the modulation amount of
the sampling frequency
c
LFO
Frequency
[Hz]
0.02...20.00 Sets the speed of the LFO
Src Off...Tempo
Selects a modulation source for
LFO speed
Amt
–20.00...
+20.00
Sets the modulation amount of
LFO speed
d
MIDI Sync Off, On
When this is on, the LFO speed is
set by BPM, Base Note, and
Times, instead of Frequency
BPM
MIDI,
40.00...
300.00
MIDI syncs to the system tempo;
40–300 sets the tempo manually
for this individual effect
Base Note ...
Selects the type of notes that
specify the LFO speed
Times x1...x32
Sets the number of notes that
specify the LFO speed
+ Max
Zero
D
-mod
– Max
Voice Bottom Voice Center Voice Top
U
I
A
A
O
E
JS X
JS +Y
JS –Y
etc…
Zero
+ Max
Talking Modulator Control
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Pre LPF
Pre LPF
High Damp Output Level
High Damp Output Level
Sampling Frequency
Decimator
Decimator
D
-mod
LFO
Resolution
Resolution
To Next Page
Loading...
