System Exclusive events supported in Sequencer mode Copy Song
191
System Exclusive events supported in Sequencer mode
You can record and play back System Exclusive events, and edit tracks that contain System Exclusive events.
SysEx messages that can be recorded in real-time
The following exclusive messages can be recorded in real‐time:
• Exclusive messages received from an external MIDI device
• Parameter changes in Sequencer mode (see table below)
• Master Volume universal exclusive messages assigned to the foot pedal or a Realtime Controls knob
Parameter change messages that you can realtime-record in Sequencer mode
*1: Solo On/Off is always controlled by events in the track,
regardless of the play/mute status of that track.
The maximum amount of exclusive data that can be
recorded at once is approximately 320 Kbytes. This size
will decrease if other events exist within the same
measure.
You cannot simultaneously record exclusive messages
received from an external MIDI device and parameter
changes produced by editing.
The events that will be recorded are controlled by the
Global P1: MIDI– MIDI Basic settings SEQ Mode
Param. MIDI Out. For Control Change, only control
change messages will be recorded. For SysEX‐Param
Change, only parameter changes and exclusive
messages will be recorded (see “Param. MIDI Out” on
page 200).
Realtime recording will not record parameter edits that
you perform by executing menu commands in the
various pages, nor changes you make by using the
Effect Preset function to recall effect parameters.
Front panel/Page Parameter
Front panel
ARP
ARP button, SELECT button, REALTIME CONTROLS 1–4 knobs (GATE, VELOCITY, SWING,
STEP )
Drum Track DRUM TRACK button
Realtime Controls
SELECT button, REALTIME CONTROLS 1–4 knobs (TONE [CUTOFF], [RESONANCE],
[SWING], [STEP], USER [1], [2], [3], [4])
P0: Play/REC, Arp
A/B
Program, Mixer Program Select, Pan, Volu me , PLAY/MUTE, Solo On/Off
*1
Tone Adjust All “Tone Adjust” parameters
P1: Controllers Controllers Setup All “Panel Switch Assign,” “Realtime Controls knob Assign” parameters
P2: EQ EQ Trim Auto Load Prog EQ, Bypass, Input Trim, High Gain, Mid Frequency, Mid Gain, Low Gain
P3: Track Param
OSC Force OSC Mode, OSC Select, Portamento
Pitch Transpose, Detune, Bend Range
Scale Use Program’s scale, Type, key, Random
P4: Zone/Delay Delay Delay Time [ms], MIDI/Tempo Sync., Base Note, Times
P7: ARP/DT
ARP Setup All parameters
Arpeggiator A/B All parameters
ARP Scan Zone All parameters
Drum Track All “Drum Track” parameters
P8: Routing/IFX
Routing1/2 Bus (IFX/Output) Select, Send1, Send2, Fx Control Bus
Insert FX Setup IFX, IFX On/Off, Chain to, Chain, Pan, Bus Sel, FX Control Bus, Send1, Send2
IFX 1–5 All effect parameters
Common FX LFO All “Common FX LFO 1, 2” parameters
P9: MFX/TFX/
LFO
Routing
MFX, MFX On/Off, Chain, Chain Direction, Chain Level, Return 1, Return 2, TFX, TFX On/Off,
Master Volume
MFX 1/2 All effect parameters
TFX All effect parameters
To Next Page
Loading...
