SEQ P3: Track Param (Track Parameters) 3–5: Pitch T01–08, 3–6: Pitch T09–16
127
3–5: Pitch T01–08,
3–6: Pitch T09–16
Here, you can make pitch‐related settings for each MIDI
track.
3–5(6)a: Location, Meter, Tempo, Tempo
Mode, Song Select, Track Select, Reso,
RPPR
3–5(6)b: Track Info
For more information, please see “0–1(2)a: Location, Meter,
Tempo, Tempo Mode, Song Select, Track Select, Reso, RPPR”
on page 109.
For more information, please see “2–1: Trim T01–08, 2–2:
Trim T09–16” on page 123.
3–5(6)c: Pitch
Track 01 (Track Number):
Transpose [–60...+00...+60]
Adjusts the pitch of each MIDI track in semitone steps.
12 units equal one octave.
Detune (Use BPM Adjust in Menu)
[–1200...+0000... +1200]
Adjusts the pitch of each MIDI track in one‐cent units.
+0000: Normal pitch.
Note: You can also use the Detune BPM Adjust menu
command (see page 103) to automatically make a detune
setting from a calculation in BPM units.
Transpose and Detune do not affect the notes
transmitted via MIDI Out. Transpose and Detune can
be controlled via MIDI RPN messages received on the
Track’s MIDI channel. The way that this works depends
on whether or not the Track uses a Drum Program.
If the Track does not use a Drum Program for example,
if it uses a Single or Double Program then MIDI RPN
Coarse Tune will control Transpose, and RPN Fine
Tune will control Detune.
If the Track uses an Drum Program, MIDI RPN Coarse
Tune and Fine Tune will be combined to control
Detune. The overall range is ±1 octave for coarse tune
and fine tune together.
Bend Range [PRG, –24...+00...+24]
Specifies the amount of pitch change that will occur when
the pitch bender is operated, in semitone units.
PRG: The pitch range specified by the program will be used.
–24…+24: This setting will be used regardless of the setting
in the program.
As long as this set to something other than PRG, you
can control the Bend Range using MIDI RPN Pitch
Bend Change messages.
Track 02...08, 09...16 (Track Number):
Here, you can make pitch‐related settings for MIDI tracks 2–
8 and 9–16. They are the same as for track 1. For more
information, please see “Track 01 (Track Number):” above.
V
3–5(6): Menu Command
•0: Memory Status see p. 163
•1: Exclusive Solo see p. 64
•2: Rename Song see p. 163
•3: Delete Song see p. 163
•4: Copy From Song see p. 163
•5: Load Template Song see p. 163
•6: Save Template Song (Save as User Template Song)
see p. 164
•7: FF/REW Speed see p. 164
•8: Set Location (Set Location for Locate Key) see p. 164
•9: GM Initialize see p. 165
•10:
Copy from Combination
see p. 166
•11: Copy from Program see p. 167
•12: Detune BPM Adjust see p. 103
For more information, please see “Sequencer: Menu
Command” on page 163.
To Next Page
Loading...
