Sequencer mode
130
Note: You can also set the note values and velocity values by
holding down an edit cell or the ENTER button and playing
a key (see OG p.10).
It is not possible to set the bottom key above the top key
of the same track. Nor is it possible for the top and
bottom slopes to overlap.
Track 02...08, 09...16 (Track Number):
These are the key zone settings for MIDI tracks 2–8 and 9–
16. They are the same as for track 1. For more information,
please see “Track 01 (Track Number):” above.
V
4–1(2): Menu Command
•0: Memory Status see p. 163
•1: Exclusive Solo see p. 64
•2: Rename Song see p. 163
•3: Delete Song see p. 163
•4: Copy From Song see p. 163
•5: Load Template Song see p. 163
•6: Save Template Song (Save as User Template Song)
see p. 164
•7: FF/REW Speed see p. 164
•8: Set Location (Set Location for Locate Key) see p. 164
•9: GM Initialize see p. 165
•10:
Copy from Combination
see p. 166
• 11: Copy from Program see p. 167
For more information, please see “Sequencer: Menu
Command” on page 163.
4–3: Vel Zone T01–08,
4–4: Vel Zone T09–16
(Velocity Zones T01–08, T09–16)
Here, you can set the Top/Bottom Velocity parameters to
specify the range of velocities that will be sounded by MIDI
tracks 1–8 and 9–16, and Top/Bottom Slope specify the range
over which the volume will be adjusted.
For more information, please see “4–3: Vel Zone T01–08, 4–4:
Vel Zone T09–16 (Velocity Zones T01–08, T09–16)” on
page 130.
These settings do not affect MIDI transmission/
reception. All note data that is received will be recorded
into the internal sequencer, and all note data from the
internal sequencer or from the keyboard will be
transmitted.
It is not possible to set the bottom velocity greater than
the top velocity for the same track. Nor can the top
slope and the bottom slope overlap.
4–3(4)a: Zone Map
This area indicates the note and velocity ranges in which
each MIDI track will sound.
For more information, please see “4–1(2)a: Zone Map” on
page 129.
4–3(4)b: Track Select, Tempo, RPPR
4–3(4)c: Track Info
For more information, please see “2–1: Trim T01–08, 2–2:
Trim T09–16” on page 123.
4–3(4)d: Velocity Zones
Track 01 (Track Number):
Top Velocity [1…127]
Specifies the maximum velocity value that will sound each
track.
Top Slope [0…120]
Specifies the number of velocity steps over which the
original volume will be reached, starting from the Top
Velocity.
0: The volume will be at the original value from the top
velocity.
120: The volume will decrease as the velocity approaches the
top velocity.
Bottom Slope [0…120]
Specifies the number of velocity steps over which the
original volume will be reached, starting from the Bottom
Velocity.
To Next Page
Loading...
