Delay 074: Echo Plus
293
074: Echo Plus
This models a famous analog tape echo unit. On the original
device, “echo” was created by a playback head, and the
“delay time” was specified by adjusting the speed of the
motor. The warmth and subtlety of the echoes it generated
made this “lo‐fi” unit a favorite with many pro musicians.
075: Tape Echo
This effect simulates a tape echo unit with three playback
heads. The distortion and tonal change typical of magnetic
tape are also reproduced.
a: Delay (Tap1) [msec]
a: Src
a: Amt
b: Tap2 Position [%]
b: Tap3 Position [%]
The delay time for Tap 2 and 3 is specified as a proportion
(%) relative to Delay (Tap1). Even if you use dynamic
modulation to control Delay (Tap1), Tap 2 and 3 will change
at the same proportion.
d: Feedback Amt
e: Feedback Amt
f: Feedback Amt
g: Feedback
The feedback output from Tap 1, 2, and 3 is mixed according
to the Feedback Amt, and then the final amount of feedback
is specified by Feedback.
076: Auto Reverse
This effect records the input signal and automatically plays
it in reverse (the effect is similar to a tape reverse sound).
a
Time [ms] 0...2700 Sets the delay time
Src Off...Tempo
Selects the modulation source of
Time [ms]
Amt –100...+100 Sets the amount for Time [ms]
b
Feedback 0...100 Sets the amount of feedback
Src Off...Tempo
Selects the modulation source of
Feedback
Amt –100...+100 Sets the amount of Feedback
c Tone 1...100 Sets the tone of the delay sound
d
Low Damp
[%]
0...100
Sets the damping amount in the
low range p.289
e
Input Level
D-mod [%]
–100...+100
Sets the modulation amount of
the input level p.284
Input Level
Mod Src
Off...Tempo
Selects the modulation source
for the input level p.284
f
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
a
Delay (Tap1)
[msec]
0...2700
Sets the delay time (tap1)
p.293
Src Off...Tempo
Selects the modulation source of
the delay time p.293
Amt
–2700...
+2700
Sets the modulation amount of
delay time p.293
b
Tap2 Position
[%]
0...100
Sets the position of Tap 2 relative
to the Tap 1 delay time the
depth of pitch variation
p.293
c
Tap3 Position
[%]
0...100
Sets the position of Tap 3 relative
to the Tap 1 delay time the
depth of pitch variation
p.293
d
Tap1 Level 0...100 Sets the Tap1 output level
Pan L, 1...99, R Sets the stereo image of tap1
Feedback
Amt
–100...+100
Sets the Tap1 feedback amount
p.293
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Delay
Feedback
Low Damp
Tone
Input Level
D-mod
Wah Flatter
D
-mod
Tap 2/ 3
Posit i on
+
Tap e
Saturation
Le ft
Ri g h t
Wet / Dry
Tri m
PanLe ve l
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Feedback
Feedback Amt
High / Low DampPre Ton e
Delay
(1)
(2)
(3)
Delay Time
e
Tap2 Level 0...100 Sets the Tap2 output level
Pan L, 1...99, R Sets the stereo image of tap2
Feedback
Amt
–100...+100
Sets the Tap2 feedback amount
p.293
f
Tap3 Level 0...100 Sets the Tap3 output level
Pan L, 1...99, R Sets the stereo image of tap3
Feedback
Amt
–100...+100
Sets the Tap3 feedback amount
p.293
g
Feedback 0...100
Sets the amount of feedback for
Taps 1, 2, and 3 p.293
Src Off...Tempo
Selects the modulation source of
feedback amount
Amt –100...+100 Sets the feedback amount
h
High Damp
[%]
0...100
Sets the damping amount in the
high range
Low Damp
[%]
0...100
Sets the damping amount in the
low range
i Saturation 0...100 Sets the distortion amount
j
Input Trim 0...100 Sets the input gain
Pre Tone 0...100 Sets the tone of the input
k
Wow Flutter
[Hz]
0.02...1.00
Sets the frequency at which
pitch variation will occur
Wow Flutter
depth
0...100 Sets the depth of pitch variation
l
Wet/Dry
Dry,
1 : 99...99 : 1,
Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
a Rec Mode Single, Multi
Sets the recording mode
p.294
b
Reverse Time
[msec]
20...2640
Sets the maximum duration of
the reverse playback p.294
Input
D-mod
Envelope Select
D
-mod
Envelope Control
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Auto Reverse
Direct
Mix
Rec/Reverse Play
Control
To Next Page
Loading...
