SEQ P8: Routing/IFX (Insert Effect) 8–3: Insert FX Setup
149
8–3: Insert FX Setup
8–3a: Track Select
For more information, please see “2–1: Trim T01–08, 2–2:
Trim T09–16” on page 123.
8–3b: Insert Effect
Here you can choose the type of each insert effect 1 through
5, its on/off status, chaining, and adjust the post‐IFX mixer
settings. For insert effects, the direct sound (Dry) is always
stereo‐in and out. The input/output configuration of the
effect sound (Wet) depends on the effect type. For
descriptions of the individual effects, please see “Effect
Guide,” beginning on page 235.
The following parameters are the same as in Program mode.
For more information, please see “8–2: Insert FX Setup” on
page 592.
However, unlike in Program mode, insert effect dynamic
modulation (Dmod) and the post‐IFX Pan: #8, Send 1, and
Send 2 are controlled on the MIDI channel specified by Ch
(Seq 8–4(5)(6)(7)(8)a). The control changes used are the same
as in Program mode.
The pan (CC#8), send 1 and 2 settings you make here will be
used when the song is played or recorded from the
beginning. If you change the settings while recording a
MIDI track, the changes will be recorded as part of the
musical data, and the settings will change when the data is
played back. You can also change these settings during
playback. However if pan (CC#8), send 1, or 2 data has been
recorded, the settings will change accordingly.
If Status (Seq 3–1(2)c) is either INT or BTH, CC#8,
CC#93, and CC#91 can be received to control the pan
following the insert effect, send 1, or send 2
respectively, and change their settings. When you
switch songs or return to the beginning of the song,
tracks whose Status is BTH, EXT, or EX2 will transmit
these settings via MIDI. This data will be transmitted
on the MIDI channels specified in the IFX 1–5 pages
(Seq 8–4(5)(6)(7)(8)a). (See Global P1: MIDI, SEQ Mode
“Track MIDI Out” on page 200)
Insert Effect:
IFX1...4 [000...193]
IFX5 [000...171]
IFX1...5: IFX On/Off [Off, On]
Chain:
IFX1: Chain to [IFX2...IFX5]
IFX2: Chain to [IFX3...IFX5]
IFX3: Chain to [IFX4...IFX5]
IFX1: Chain [Off, On]
IFX2: Chain [Off, On]
IFX3: Chain [Off, On]
IFX4: Chain [Off, On]
Pan:#8:
Pan: #8 (Post IFX PanCC#8) [L000...C064...R127]
Bus:
Bus (Bus Select) [Off, L/R]
Ctrl (FX Control Bus) [Off, 1, 2]
Send1/2:
Send1 [000...127]
Send2 [000...127]
For more information, please see “8–2: Insert FX Setup” on
page 59.
V
8–3: Menu Command
•0: Memory Status see p. 163
•1: Exclusive Solo see p. 64
•2: Copy Insert Effect see p. 66
•3: Swap Insert Effect see p. 67
•4: FF/REW Speed see p. 164
•5: Set Location (Set Location for Locate Key) see p. 164
•6: Put Effect Setting to Track see p. 184
For more information, please see “Sequencer: Menu
Command” on page 163.
To Next Page
Loading...
