Korg Krome - 080: St.bpm Mtap Delay (Stereo BPM Multitap Delay); 081: St.bpm Mod. Delay (Stereo BPM Modulation Delay)

296
080: St.BPM Mtap Delay (Stereo
BPM Multitap Delay)
This is a stereo multi‐tapped delay that lets you set the delay
time to match the tempo of the song.
081: St.BPM Mod. Delay (Stereo
BPM Modulation Delay)
This is a stereo modulation delay that lets you synchronize
the delay time to the tempo of the song.
a Mode
Normal, Cross
Feedback,
Cross Pan1,
Cross Pan2
Switches the left and right delay
routing p.290
b
BPM
MIDI,
40.00...
300.00
MIDI syncs to the system tempo;
40–300 sets the tempo manually
for this individual effect p.285
Time Over? 1 ---, OVER!
Displays an error message when
the delay time for Tap1 exceeds
the upper limit
p.295
2 ---, OVER!
Displays an error message when
the delay time for Tap2 exceeds
the upper limit
p.295
c
Tap 1 Base
Note
...
Selects the type of notes to
specify the delay time for Tap1
p.285
Times x1...x32
Sets the number of notes to
specify the delay time for Tap1
p.285
d
Tap 2 Base
Note
...
Selects the type of notes to
specify the delay time for Tap2
p.285
Times x1...x32
Sets the number of notes to
specify the delay time for Tap2
p.285
e Tap1 Level 0...100
Sets the Tap1 output level
p.290
f
Feedback
(Tap2)
–100...+100 Sets the Tap2 feedback amount
Src Off...Tempo
Selects the modulation source of
the Tap2 feedback amount
Amt –100...+100
Sets the modulation amount of
the Tap2 feedback amount
g
High Damp
[%]
0...100
Sets the damping amount in the
high range p.289
Low Damp
[%]
0...100
Sets the damping amount in the
low range p.289
h
Input Level
D-mod [%]
–100...+100
Sets the modulation amount of
the input level p.284
Src Off...Tempo
Selects the modulation source
for the input level p.284
i
Spread –100...+100
Sets the width of the stereo
image of the effect sound
p.289
Src Off...Tempo
Selects the modulation source of
the effect sound’s stereo image
width
Amt –100...+100
Sets the modulation amount of
the effect sound’s stereo image
width
j
Wet/Dry
Dry, 1 : 99...
99 :
1, W
et
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
Tempo
BPM
BPM
Base Note x Times
Base Note x Times
Left
Right
Feedback
Spread
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Input Level D-mod
Input Level D-mod
High Damp
Low Damp
High Damp
Low Damp
Delay
Delay
Feedback
Tap1 Level
Mode
Mode
(1)
(2)
(1)
(2)
Tap1=(1)
Tap2=(2)
a
Modulation
Mode
LFO, D-mod
Switches between LFO
modulation control and
modulation source control
b
D-mod
Modulation
L/R:+/+,
L/R:+/–
Reversed L/R control by
modulation source p.291
Src Off...Tempo
Selects the modulation source
that controls delay time
Response 0...30
Sets the rate of response to the
modulation source
c
LFO
Waveform
Triangle, Sine Selects the LFO Waveform
LFO Shape –100...+100
Changes the curvature of the
LFO Waveform p.258
d
LFO D-mod
Sync
Off, On
Switches LFO reset off/on
p.291
Src Off...Tempo
Selects the modulation source
that resets the LFO
e
LFO
Frequency
[Hz]
0.02...20.00 Sets the speed of the LFO p.259
f
MIDI Sync Off, On
When this is on, the LFO speed is
set by BPM, Base Note, and
Times, instead of Frequency
p.257
BPM
MIDI,
40.00...
300.00
MIDI syncs to the system tempo;
40–300 sets the tempo manually
for this individual effect p.257
Base Note ...
Selects the type of notes that
specify the LFO speed p.257
Times x1...x32
Sets the number of notes that
specify the LFO speed p.257
g
LFO Type
Individual,
Common1,
Common2
Selects either (individual) LFO,
Common FX LFO1, or Common
LFO2 p.257
Common
LFO Offset
[deg]
–180...+180
Sets the phase offset when Type
= Common 1 or Common 2
p.257
h
L LFO Phase
[deg]
–180...+180
Sets the phase obtained when
the left LFO is reset p.291
Depth 0...200
Sets the depth of the left LFO
modulation
i
R LFO Phase
[deg]
–180...+180
Sets the phase obtained when
the right LFO is reset p.291
Depth 0...200
Sets the depth of the right LFO
modulation
j
BPM(Delay)
MIDI,
40.00...
300.00
MIDI syncs to the system tempo;
40–300 sets the tempo manually
for this individual effect p.285
Time Over? L ---, OVER!
Display the error message if the
le
f
t channel delay time exceeds
the upper limit p.297
R ---, OVER!
Display the error message if the
right channel delay time exceeds
the upper limit p.297
Tempo
BPM
BPM
Base Note x Times
Base Note x Times
Left
Right
Feedback
LFO Phase
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
LFO: Tri / Sine
Modulation Mode
D-mod
LFO
D
-mod
Delay
Delay
L/R: +/+ +/–
LFO Shape
Response
LFO Sync