Overdrive, Amp models, and Mic models (OD Amp Mic) 028: Mic Model+PreAmp (Mic Modeling + PreAmp)
267
028: Mic Model+PreAmp (Mic
Modeling + PreAmp)
This effect simulates a mic and vacuum tube preamp. You
can choose from various types of mic and positions to create
differing sonic characters.
b: Mic Position
This expresses the effect that the mic position has on the
sound. The Close setting is the closest mic position, and the
Far setting is the farthest.
a Mic Type
Vintage
Dynamic,
Multi
Condenser,
Percussion
Condenser,
Drums Dynamic,
Vocal Dynamic,
Multi Dynamic,
Vocal
Condenser,
Vocal Tube,
Kick Dynamic
Selects the type of mic
b Mic Position
Close, On, Off,
Far
Sets the mic placement distance
p.267
c
Tube Low Cut
[Hz]
Thru,
21...8.00k
Sets the frequency of the low cut
filter
High Cut [Hz]
53...20.00k,
Thru
Sets the frequency of the high
cut filter
d
Tube Gain
[dB]
–24.0...+24.0
Sets the input gain to the
vacuum tube preamp
Saturation
[%]
0...100
Sets the input/output response
of the preamp p.266
e Tube Bias 0...100
Sets the bias level of the preamp
p.266
f
Tube Output
Level [dB]
–48.0...+0.0
Sets the output level of the
preamp
g
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry
+
Tube Pre AmpMic Simulation
Left
Right
Wet / Dry
Output Level
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out