SEQ P0: Play/REC 0–9: Play Loop T01–08, 0–10: Play Loop T09–16
119
0–8c: Metronome Setup
Here, you can make metronome settings.
Sound [Only REC, REC & Play, Off]
Only REC: The metronome will sound only during
recording.
REC & Play: The metronome will sound during recording
and playback.
Off: The metronome will not sound during playback or
recording. However, the pre‐count metronome will sound
before recording begins.
Level [000…127]
Sets the volume of the metronome.
Bus (Output) Select [L/R, L, R]
Selects the output destination of the metronome sound.
L/R: Output from AUDIO OUTPUT L/Mono and R.
L: Output from AUDIO OUTPUT L/Mono.
R: Output from AUDIO OUTPUT R.
Precount [Measure] [0…2]
Specifies the pre‐count that will occur before recording
begins.
With a setting of 0, recording will begin the instant you
press the START/STOP ( ) button (after first pressing
the REC ( ) button).
V
0–8: Menu Command
• 0: Memory Status see p. 163
• 1: Exclusive Solo see p. 64
• 2: Rename Song see p. 163
• 3: Delete Song see p. 163
• 4: Copy From Song see p. 163
• 5: Load Template Song see p. 163
• 6: Save Template Song (Save as User Template Song)
see p. 164
• 7: FF/REW Speed see p. 164
• 8: Set Location (Set Location for Locate Key) see p. 164
• 9: GM Initialize see p. 165
•10:
Copy from Combination
see p. 166
•11: Copy from Program see p. 167
For more information, please see “Sequencer: Menu
Command” on page 163.
0–9: Play Loop T01–08,
0–10: Play Loop T09–16
When playing or recording a song, you can independently
loop the MIDI tracks.
0–9(10)a: Location, Meter, Tempo, Tempo
Mode, Song Select, Track
Select, Reso, RPPR
For more information, please see “0–1: Program T01–08, 0–2:
Program T09–16” on page 109.
0–9(10)b: Play Loop
Selected Track Info
This displays information about the currently selected MIDI
track. For more information, please see “0–1(2)b: Track
Program Select” on page 111.
Track 01 (Track Number):
Category [Category Name]
Indicates the category.
Track Play Loop [Off, On]
Specifies looping for a MIDI track.
On (checked): That track will loop between Loop Start
Measure and Loop End Measure.
Loop Start Measure [001...999]
Specifies the first measure of the loop.
Loop End Measure [001...999]
Specifies the last measure of the loop.
Play Intro [Off, On]
On (checked): After the measures before the specified Loop
Start Measure are played once, the region of Loop Start
Measure – Loop End Measure will be played repeatedly.
For example, you can use this on a drum track to make it
play a fill‐in and then begin looping.
Off (unchecked): Playback will begin from the Loop Start
Measure, and will begin looping immediately.
This will be valid if Track Play Loop is checked and
Loop Start Measure is set to other than 001.
0–9a
0–9b
0–9
Menu
To Next Page
Loading...
