Korg Krome - Page 173

Sequencer: Menu Command GM Initialize
165
GM Initialize
GM Initialize is available on all of the tabs under the Play/
REC, Play/REC Control, Controllers, EQ, Track Param,
Zone/Delay, MIDI Filter 1, MIDI Filter2, and Drum Track
pages.
This command transmits a GM System On message to the
Sequencer mode, resetting all tracks to the GM settings. For
more information, please see “GM Initialize” on page 165.
In Sequencer mode, when a GM System On message is
received from an external device, or if a GM System On
message is recorded in the sequence data, the KROME
will be reset to settings appropriate for GM just as if
you had executed this command. However, in these
cases, the various P9: MFX/TFX/LFO parameters will
not be reset.
GM Initialize List
Page Parameter Track 1–9, 11–16 Track 10
P0
Program T01–08, T09–16
Program Select G001 g(d)001
Play/Mute, Solo ‐ ‐ Setting remains unchanged
Mixer T01–08, 09–16
Pan C064 C064
Volume 100 100
P2
EQ Trim T01–08, T09–16
Auto Load Prog EQ On On
Bypass Off Off
Input Trim 99 99
EQ Gain T01–08, T09–16
High Gain [dB] +00.0 +00.0
Mid Frequency [Hz] 3.20k 3.20k
Mid Gain [dB] +00.0 +00.0
Low Gain [dB] +00.0 +00.0
P3
MIDI T01–08, T09–16
Status ‐‐Setting remains unchanged
MIDI Channel ‐‐Setting remains unchanged
Bank Select MSB/LSB 000 000
OSC T01–08, T09–16
Force OSC Mode ‐‐Setting remains unchanged
OSC Select ‐‐Setting remains unchanged
Portamento Off Off
Pitch T01–08, T09–16
Transpose +00 +00
Detune +0000 +0000
Bend Range +02 +02
Scale T01–08, T09–16 Use Program’s Scale ‐‐Setting remains unchanged
P4
Key Zone T01–08, T09–16 C–1…G9 (Slope=000) C–1…G9
Vel Zone T01–08, T09–16 001…127 (Slope=000) 001…127
Delay T01–08, T09–16
MIDI Tempo Sync. Off Off
Time 0000 0000
P5 MIDI Filter1, 2 On On
P7
Arpeggiator Various parameters ‐ Setting remains unchanged
Drum Track Various parameters ‐ Setting remains unchanged
P8
Routing1 T01–08, T09–
16
Bus (IFX/Output) Select L/R L/R
Send1 (MFX1) 0 0
Send2 (MFX2) 40 40
Insert FX Setup
IFX1…5 ‐‐Setting remains unchanged
Pan: #8 ‐‐Setting remains unchanged
FX Control Bus ‐‐Setting remains unchanged
Send1/2 ‐‐Setting remains unchanged
Other parameter ‐‐Setting remains unchanged
Routing2 T01–08, T09–
16
FX Control Bus Off Off
Common FX LFO Other parameters ‐‐Setting remains unchanged
P9
Routing
MFX1 ‐‐Stereo Chorus
MFX2 ‐‐Reverb Smooth Hall
Chain ‐‐Off
Chain Direction ‐‐1→2
Level ‐‐127
Return1 ‐‐127
Return 2 ‐‐50
Other MFX parameters ‐‐‐Setting remains unchanged
TFX ‐‐‐Setting remains unchanged
Master Level ‐‐‐Setting remains unchanged