SEQ P6: Track Edit 6–2: Track View
139
Note: When selecting, the upper line FROM MEASURE or
To END of MEASURE will briefly turn blue, and will
indicate the selected measure number.
End point select tool
Use this to specify the last measure (To END of MEASURE)
of the range of measures that you want to edit.
Choose this tool, and then press a measure in a track to
specify the ending measure (and the track). Continue
holding down the starting measure, drag to the left, and
release at the end of the desired selection. While dragging,
you can drag across a scroll button to scroll through the
measures while maintaining the selection.
If more than one measure is selected even though you
actually wanted to select only one measure, simply continue
pressing for approximately one second; the single measure
you’re pressing will be selected.
Note: When selecting, the upper line FROM MEASURE or
To END of MEASURE will briefly turn blue, and will
indicate the selected measure number.
Example)
Using the Start Point Select tool to specify a region
1. Press the tool.
2. Press the desired starting measure for the track in
which you want to select a region.
3. While continuing to press, drag to the last measure of
the desired range, and release your finger.
You can scroll the measure display by dragging your finger
onto or across a scroll bar.
The edit region will be selected and highlighted.
Example)
Using the End Point Select tool to specify a region
1. Press the tool.
2. Press the desired ending measure for the track in which
you want to select a region.
3. While continuing to press, drag to the first measure of
the desired range, and release your finger.
You can scroll the measure display by dragging your finger
onto or across a scroll bar.
The edit region will be selected and highlighted.
Move tool
Use this to move the measures of the region you’ve specified.
Use the
or
tool to select the region that you want to
move, and then choose this tool. Press the move‐destination
measure or drag the selected region of measures to move them.
If data exists at the move‐destination, the Drag Move dialog
box will appear, allowing you to select whether to overwrite
or keep the data at the destination.
Note: This operation is equivalent to executing the Move
Measure menu command with Mode set to Stay (see p.179).
Example)
Moving the events of measures 1–2 to measures 5–6
1. Press the tool.
2. Drag over measures 1–2 to specify the edit region.
3. Press the tool.
4. Press measure 5 (the move-destination measure). Alter-
natively, drag the edit region to measure 5.
5. In this example, an event exists in the move-destination
measure, so the Drag Move dialog box will appear.
Overwrite will overwrite the source data over the destination
data (replacing the destination data with the source data).
Merge will combine the source and destination data.
Press the OK button to execute the move.
If there are no events in the move‐destination measures, this
dialog box will not appear; the move will occur immediately.
1
2
34
To Next Page
Loading...
