Sequencer mode
172
Toolbox
Select Event tool
Use this to select an event in the note view area or control
view area. You can move an event by dragging it.
Length Edit tool: Only for Note view
Use this tool to modify the length of a note; press the event
and drag it.
Put Event tool
Use this to create an event.
If you press inside the note view area, a note will be added.
The Grid Resolution setting in Piano Roll Setup specifies
the length of the inserted note. The note will be inserted
with a velocity of 100.
If you press inside the control view area, a control event
specified by the control view select Ctrl setting will be
created. You can create continuous data by dragging.
However, PAft (polyphonic aftertouch events) cannot be
created.
You can’t create events in a measure where a pattern has
already been placed.
Erase Event tool
Use this to erase an event.
If you press inside the note view area, the note will be
erased.
If you press control data in the control view area, that data
will be erased. If velocity is displayed, the note event will be
deleted at the same time.
Limited to Erase, you can erase multiple events in a single
operation. Drag to enclose the events you want to erase
(they will light blue), and then release; the events in the
specified region will be erased. However, PAft (polyphonic
aftertouch events) cannot be erased.
Grab tool
You can move the displayed region by dragging over the
note view area or control view area.
Style Select tool
Use this to switch the note event display between
the conventional type and a type suitable for a drum
kit.
View control
Zoom
Use these buttons to zoom in/out the data shown in the note
view area or control view area.
From the left, these buttons zoom‐in (magnify) the vertical
axis, zoom‐out (shrink) the vertical axis, zoom‐in (magnify)
the horizontal axis, and zoom‐out (shrink) the horizontal
axis.
Vertical zoom‐in/out will zoom centered on the selected
event.
Horizontal zoom‐in/out will zoom based on the measure
shown at the far left.
Scroll
Use these buttons to scroll the note view area.
View area height select
Pressing these buttons will change the displayed size of the
note view area and the control view area.
Editing notes
Note: If you decide to cancel a change, press the Done
button to finish editing, and then press the COMPARE
button. You will return to the state prior to opening the
Piano Roll dialog box.
Moving a note
1. Press the tool.
2. Press the note event that you want to move.
The note will light blue. Continue pressing, and event
information will be displayed in the upper left (or upper
right).
3. Continuing to press the note, drag it up/down/left/
right.
Dragging vertically will change the note’s pitch, and
dragging horizontally will change its location.
To Next Page
Loading...
