PROG P0: Play 0–7: Tone Adjust
11
modulation from LFO1, as described under “Intensity to A”
on page 30.
Filter LFO 1 Intensity to B. (–99...+99, Absolute)
This controls the depth and direction of Filter B cutoff
modulation from LFO1, as described under “Intensity to B”
on page 31.
Filter LFO 2 Intensity to A. (–99...+99, Absolute)
This controls the depth and direction of Filter A cutoff
modulation from LFO2, as described under “Intensity to A”
on page 30.
Filter LFO 2 Intensity to B. (–99...+99, Absolute)
This controls the depth and direction of Filter B cutoff
modulation from LFO2, as described under “Intensity to B”
on page 31.
Pitch LFO 1 AMS Intensity. (–12.00...+12.00, Absolute)
You can use an AMS source, such as aftertouch, to modulate
the depth of pitch modulation (vibrato) from LFO1. This
controls the intensity of that AMS modulation. For more
information, please see “Intensity” on page 21.
Pitch LFO 2 AMS Intensity.
(–12.00...+12.00, Absolute)
This is similar to Pitch LFO 1 AMS Intensity, above.
Default Tone Adjust Settings
You can use the Tone Adjust function to edit all of the
important program parameters on this single page. Most of
the preset sounds use the default layout shown below. You
can customize these default settings for each program.
For details on the Tone Adjust function, please see “0–7b:
Selected parameter information” on page 8.
Tone Adjust parameters
This applies to common tone adjust parameters and tone
adjust parameters following the “0–7b: Selected parameter
information” on page 8.
Default Tone Adjust Settings
V
0–7: Menu Command
•0: Write Program see p. 64
•1: Exclusive Solo see p. 64
•2: Auto Song Setup see p. 65
•3: Copy Tone Adjust see p. 65
•4: Reset Tone Adjust see p. 65
For more information, please see “Program: Menu
Command” on page 64.
Controller Default settings
SW1 [OSC1] Transpose
SW2 [OSC2] Transpose
SW3 [OSC1] Tune
SW4 [OSC2] Tune
SW5 [OSC1]MS/DKit Select
SW6 Filter Cutoff
SW7 Filter Resonance
SW8 Filter EG Intensity
Slider1 [OSC1&2] Pitch Stretch
Slider2 [OSC1] Filter LFO1 Int A
Slider3 [OSC1] Amp LFO Int
Slider4 [OSC1] Drive
Slider5 F/A EG Attack Time
Slider6 F/A EG Decay Time
Slider7 F/A EG Sustain Level
Slider8 F/A EG Release Time
To Next Page
Loading...
