Sequencer: Menu Command Modify Velocity
183
Modify Velocity
Modify Velocity is available on all of the tabs of the Track
Edit page.
This command modifies the velocity values of notes in the
specified area so that they will change over time according
to a selected curve.
1. In Track Select, specify the track whose velocity will be
modified.
2. Select “Modify Velocity” to open the dialog box.
3. Specify the range in which note velocity will be modi-
fied.
From Measure and To End of Measure specify the measure,
and Beat.Tick specify the beat and clock. (By default, From
Measure and To End of Measure will be set to the range
that you specified in the Track Edit page.)
4. Specify the range of notes that will be affected by the
Modify Velocity command.
Note Range: Bottom is the lower limit, and Top is the upper
limit. If you wish to edit all notes, set Bottom to C–1 and Top
to G9.
5. In Velocity Start Value, specify the value at which the
velocity data will start, and in End Value, specify the
final velocity value.
6. In Intensity, specify the degree to which the velocity
data will be adjusted toward the curve you specify in
step 7.
With a setting of 0 [%], the velocity will not change. With a
setting of 100 [%], the velocity will be exactly as described by
the curve.
7. Curve lets you select from six types of curve to specify
how the velocity will change over time.
* The six curves are as follows.
Create Exclusive Data
This command creates universal system exclusive messages
or KROME parameter change messages in the specified
region of a MIDI track.
1. Use Track Select to specify the MIDI track in which you
want to create exclusive data.
2. Choose Create Excl Data to open the dialog box.
3. Specify the region into which you want to insert uni-
versal system exclusive messages or KROME parameter
change messages.
Use From Measure and To Measure to specify the measures,
and Beat.Tick to specify the beat and clock. (By default,
From Measure and To Measure will be set to the region you
specified in the Track Edit page.)
4. Use Kind to specify the type of universal system exclu-
sive message or KROME parameter change message
that you want to create.
For more information, please see “Universal system
exclusive” on page 365.
5. Use Start Value to specify the starting value of the uni-
versal system exclusive message or KROME parameter
change message, and End Value to specify the ending
value.
6. Press the OK button to execute the Create Exclusive
Data operation. If you decide not to execute, press the
Cancel button.
127
Velocity
1
Start
Measure
End
Measure
Curve 1
Start
Measure
End
Measure
Curve 2
Start
Measure
End
Measure
Curve 3
Start
Measure
End
Measure
Curve 4
Start
Measure
End
Measure
Curve 5
Start
Measure
End
Measure
Rndm
RANDOM
127
Velocity
1
127
Velocity
1
127
Velocity
1
127
Velocity
1
127
Velocity
1
For a Start Velocity of 1 and End Velocity of 127
3:00 3:24 3:48 3:72 4:00 4:24 4:48
Location
EQ High Gain
Previous data
Start location End location
End Value
Start Value
default value
Example: The parameter is EQ High Gain. Starting location is 3:48, ending location is 4:24,
and end value is set to +12.0. This will cause the EQ High Gain value to begin
changing from 3:48, and reach a value of +12.0 at 4:24.
-18.0
0
+18.0
+12.0
To Next Page
Loading...
