Global mode
220
Reset Controller MIDI Assign
Reset Controller MIDI Assign is available on the MIDI CC#
Assign tab of the Controllers page.
This automatically assigns the MIDI control change
messages for each controller of the P2: Controllers– MIDI
CC# Assign page.
1. Set the To field to the desired reset method.
All Off: All settings will be Off.
Default Setting: The controlllers will all be set to Off; the X–
Y control will be set to its default CCs.
CC Default: The parameters will be reset to the typical
settings, including the standard settings for the controlllers.
If you want to use the controllers with an external MIDI
device, we recommend using this setting.
(You are also free to assign different MIDI control change
messages to the controllers, if you wish.)
The default values are shown in the table below.
Reset Controller MIDI Assign Default
Copy Scale
Copy Scale is available on the Scales page.
This command copies data from a preset scale to a user scale
or copies a user scale to another user scale location. For
details on the preset scales, please see Ty pe (Prog 1–2d).
1. Use the From field to select the copy-source scale.
If you select Pure Major or Pure Minor, specify the Key
(located at the right) as well.
Stretch cannot be selected if To is User All Notes Scale.
2. In To, selects the copy destination scale.
Write Drum Kits
Write Drum Kits is available on the Drum Kit page.
This saves all drum kits 00 (INT)–47 (USER).
You must write an edited drum kit if you want to keep it.
Edited drum kits cannot be recovered if you turn off the
power before saving them.
Note: You can also access and execute this command by
pressing the WRITE button.
Rename Drum Kit
Rename Drum Kits is available on the Drum Kit page.
This renames a drum kit.
For more information, please see “Editing names” on
page 117 of the Operation guide.
Copy Drum Kit
Copy Drum Kits is available on the Drum Kit page.
This command copies the settings of another drum kit to the
currently‐edited drum kit.
Note: Drum kits 48 (GM)–56 (GM) cannot be edited, but you
may copy them to another drum kit and then edit them.
Select the copy source drum kit (From).
When you execute Copy Drum Kit, the settings of the
currently selected drum kit will be overwritten.
Copy Key Setup
Copy Key Setup is available on the Drum Kit page.
This command copies the settings of an individual key to
another key. You can also copy settings from two or more
contiguous keys at once.
1. In the From Key fields, select the range of keys that you
wish to copy.
2. In theTo Key field, select the copy destination key. If
you selected two or more keys in the From Key field,
their settings will be copied to the keys starting at the
To Key and continuing upward.
Swap Key Setup
Swap Key Setup is available on the Drum Kit page.
This command exchanges (swaps) the settings of one key
with the settings of another key.
Use Source Key 1 and Source Key 2 to specify the keys
whose settings you want to swap.
Controllers \ to Default Setting CC Default
ARP Controllers
On/Off CC#14 (CC#14)
Knob 1 CC#22 (CC#22)
Knob 2 CC#23 (CC#23)
Knob 3 CC#24 (CC#24)
Knob 4 CC#25 (CC#25)
To Next Page
Loading...
