Effect Guide
242
In the next diagram, IFX1’s Chain check box is checked and
Chain to set to IFX2, sending the output of IFX1 to IFX2.
Timbre 1 is being processed by IFX1: Stereo Compressor and
IFX2: 038: Stereo Flanger effects. Timbre 2 is being processed
by the IFX2: 038: Stereo Flanger effect. The Routing Map
area of the next diagram shows these settings. (With these
settings, IFX3–5 are not being used.)
Drum Programs in Combination and Sequencer
modes
If you’ve selected a drum program (Oscillator Mode=
Drums or Double Drums) for a timbre (in Combination
mode) or track (in Sequencer mode), the DKit setting will be
available as a choice for Bus (IFX/Output) Select (see the
following diagram).
If Bus (IFX/Output) Select is set to DKit, of each key in the
drum kit, letting you specify the bus to which each drum
instrument will be sent. For example you can send snare
sounds to IFX1, kick sounds to IFX2, and other drum sounds
to L/MONO and R.
If this check box is unchecked, all drum instruments will be
output according to the Bus (IFX/Output) Select setting of
each timbre/track (Combi/Seq 8–1(2)d). This lets you apply
an insert effect to all of the drum instruments in that drum
kit.
Drum Kit IFX Patch
If Bus (IFX/Output) Select is set to DKit, you’ll be able to
select the menu command DrumKit IFX Patch.
This option allows you to change the routing of the Insert
Effects temporarily by changing Bus (IFX/Output) Select for
each key.
For example, assume that the Drum kit key assignment is set
so that a snare sound is routed to IFX1 and a kick sound is
routed to IFX2 etc., IFX1–3. In this case, if you wish to assign
IFX 1 and 2 to the Programs used by other timbres and
tracks, you can view the routing so that these Drum kit
sounds are routed to IFX3 and IFX5 respectively.
Patching is possible only if the Bus (IFX/Output) Select
(Global 5–5b) setting of each key in the drum kit is assigned
to an insert effect. The state of these settings is also shown in
the Routing Map. Make the desired settings for DrumKit
IFX Patch, and press the OK button to execute.
If you want to revert to the original settings of the drum kit,
execute Drum Kit IFX Patch with the settings IFX1 → IFX1,
IFX2 → IFX2, IFX3 → IFX3, IFX4 → IFX4, and IFX5 → IFX5.
In the following diagram, Drum Program is assigned to
Timbre 1, and normal Programs are assigned to Timbres 2
and 3. Bus (IFX/Output) Select is set to DKit for Timbre 1,
IFX1 for Timbre 2, and IFX2 for Timbre 3. With Timbre 1, the
Bus (IFX/Output) Select (Global 5–5b) for Drum kit setting
becomes effective.
DrumKit IFX Patch dialog
Use the DrumKit IFX Patch menu command if you want the
drum program to use effects other than timbres 2 and 3.
Choose DrumKit IFX Patch from the page menu, and
temporarily send the drum kit IFX1 to IFX3, IFX2 to IFX4,
and IFX3 to IFX5. Executing with these settings will
temporarily change the effects to which the drum kit is
being sent (see the following diagram).
To Next Page
Loading...
