Korg Krome - Page 306

298
a: Tap1 Dmod Src
b: Tap1 Delay Note
b: Times
c: Tap1 Dmod Note
c: Times
If Tap1 Dmod Src is Off or the selected modulation is at 0,
the delay time will be the length specified by Tap1 Delay
Note and Times.
If Tap1 Dmod Src is other than Off, the delay time will
change so that it will be as specified by Tap1 Dmod Note
and Times when the maximum modulation is reached.
b: Time Over?
You can set the delay time up to 5,400msec. If the delay time
exceeds this limit, the error message “OVER!” appears in the
display. Set the delay time parameters so that this message
will not appear. Time Over? is only a display parameter.
d
Tap2 Position
[%]
0...100
Sets the position of Tap 2 relative
to the Tap 1 delay time the
depth of pitch variation
p.293
e
Tap3 Position
[%]
0...100
Sets the position of Tap 3 relative
to the Tap 1 delay time the
depth of pitch variation
p.293
f
Tap1 Level 0...100 Sets the Tap1 output level
Pan L, 1...99, R Sets the stereo image of tap1
Feedback
Amt
–100...+100
Sets the Tap1 feedback amount
p.293
g
Tap2 Level 0...100 Sets the Tap2 output level
Pan L, 1...99, R Sets the stereo image of tap2
Feedback
Amt
–100...+100
Sets the Tap2 feedback amount
p.293
h
Tap3 Level 0...100 Sets the Tap3 output level
Pan L, 1...99, R Sets the stereo image of tap3
Feedback
Amt
–100...+100
Sets the Tap3 feedback amount
p.293
i
Feedback 0...100
Sets the amount of feedback for
Taps 1, 2, and 3 p.293
Src Off...Tempo
Selects the modulation source of
feedback amount
Amt –100...+100
Sets the depth by which
feedback amount will be
modulated
j
High Damp
[%]
0...100
Sets the damping amount in the
high range
Low Damp
[%]
0...100
Sets the damping amount in the
low range
k Saturation 0...100 Sets the distortion amount
l
Input Trim 0...100 Sets the input gain
Pre Tone 0...100 Sets the tone of the input
m
Wow Flutter
[Hz]
0.02...1.00
Sets the frequency at which
pitch variation will occur
Wow Flutter
depth
0...100 Sets the depth of pitch variation
n
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount for
Wet/Dry