Krone Comprima V 180 - Page 223

Malfunction, cause and remedy 17
Faults of the electrics/electronics 17.5
Comprima V 180
Original Operating Instructions 150001053_00_en 223
Possible cause Remedy
FMI 13: The wrong configuration values were saved.
An invalid machine type has
been specified.
 Adjust the machine type.
 Restart the machine.
The configuration parameters
of the machine are invalid.
 Configure the machine correctly.
 Restart the machine.
522530-
KMB1
Possible cause Remedy
FMI 31: The condition has been fulfilled.
The wiring is faulty.
 Check wiring.
The control unit is defective.
 Note the error number with the FMI and contact the KRONE
service partner.
522531-
KMB1
Possible cause Remedy
FMI 19: There is a CAN communication malfunction.
The wiring is faulty.
 Check wiring.
The control unit is defective.
 Note the error number with the FMI and contact the KRONE
service partner.
522532-
KMB2
Possible cause Remedy
FMI 31: The condition has been fulfilled.
The wiring is faulty.
 Check wiring.
The control unit is defective.
 Note the error number with the FMI and contact the KRONE
service partner.
522533-
KMB2
Possible cause Remedy
FMI 19: There is a CAN communication malfunction.
The wiring is faulty.
 Check wiring.
The control unit is defective.
 Note the error number with the FMI and contact the KRONE
service partner.
522540-
FM 1
Possible cause Remedy
FMI 31: The condition has been fulfilled.
The wiring is faulty.
 Check wiring.
The control unit is defective.
 Note the error number with the FMI and contact the KRONE
service partner.