Krone Comprima V 180 - Page 239

Index 22
Comprima V 180
Original Operating Instructions 150001053_00_en 239
T
Target group of this document ............................. 8
Technical data .................................................... 40
Technical limit values ......................................... 17
Technically sound state of the machine ............. 16
Term “machine” .................................................... 9
Terminal
Actuator test ........................................... 138
Baling pressure adjustment, electronic .. 122
Configuring TIM software ....................... 129
Counter .................................................. 126
Filling correction ..................................... 123
ISOBUS settings .................................... 129
Manual operation (net and chamber film
wrapping) ............................................... 125
Manual operation (net wrapping) ........... 124
Number of film layers ............................. 119
Number of net layers.............................. 118
Pre-signalling ......................................... 119
Select menu level................................... 114
Select tying method (net and chamber film
wrapping) ............................................... 122
Sensor test ............................................. 133
Setting units ............................................. 99
Settings .................................................. 132
Software info .......................................... 140
Switching between terminals.................. 132
Switching between the terminals............ 131
Tying in the menu level .......................... 117
Tying start delay (chamber film wrapping) ....
121
Tying start delay (net wrapping)............. 120
Terminal machine functions ............................. 102
Terminal menus................................................ 112
Tightening torque: Wheel nuts ......................... 172
Tightening torques............................................ 166
TIM
Keys on the working screen ................... 108
Mode of operation .................................. 108
TIM displays and keys on the working screen.. 108
Total counter .................................................... 128
Touchable display .............................................. 96
Tying actuator position
Adjust the sensor ................................... 135
Tying in the menu level .................................... 116
Tying start delay (chamber film wrapping, terminal)
......................................................................... 121
Tying start delay (net wrapping, terminal) ........ 120
U
Universal shaft.................................................... 47
Adjusting the length of the........................ 47
Unsuitable consumables .................................... 21
Using the bale ejector................................. 87, 159
Using the stop cock of the tailgate ..................... 73
V
Validity.................................................................. 8
Varying functions to KRONE ISOBUS terminal 101
W
Warning signs..................................................... 10
Warnings of property damage/environmental
damage .............................................................. 11
Waste disposal ................................................. 230