11-4
Troubleshooting > General Troubles
Printouts are curled.
― Turn the orientation 180 degrees
around in which the paper is
positioned.
3-19
Is the paper damp? Replace the paper with new paper. 3-17
If you experience frequent problems,
turn the cassette heater switch on.
2-5
This completes the
printer driver
installation.
Is the driver installed with the host
name while Wi-Fi or Wi-Fi Direct
function is available?
Specify the IP address instead of the
host name.
2-28
Cannot print.
Check the power cord. Connect both ends of the power cord
securely.
2-9
Is the machine powered on? Turn on the power switch. 2-10
Are the USB cable and network cable
connected?
Connect the correct USB cable and
network cable securely.
2-9
2-9
Is the print job paused? Resume printing. 7-9
When the wired or Wi-Fi network is
configured using the name
resolution, does the IP address
(private address) of the other
network which can not access
coexists?
The number of host name and
domain name which can be used
with the machine is one respectively.
Configure the network under this
restriction. Configure the network
under this restriction.
―
Change the settings of name
resolution such as NetBEUI and
DNS, or network environment
settings.
Command
Center RX
User Guide
Select Wi-Fi, Wired Network or
Optional Network as an unlimited use
network on Primary Network (Client).
8-52
Set to [Wired Network] or [Wi-Fi]
either one of [Enable], and set the
other setting to [Disable].
8-42
Cannot print with
USB memory.
USB memory not
recognized.
Is the USB host blocked [Block]? Select [Unblock] in the USB host
settings.
8-52
― Check that the USB memory is
securely plugged into the machine.
―
While “On" is set to
[Auto-IP], the IP
address is not
assigned
automatically.
Is a value other than "0.0.0.0"
entered for the IP address of TCP/
IP(v4)?
Enter "0.0.0.0" for the IP address of
TCP/IP(v4).
2-13
Symptom Checkpoints Corrective Actions Reference
Page
To Next Page
Loading...
Need help?
General
