11-20
Troubleshooting > Responding to Messages
T
SSD error. - An error has occurred on SSD. Job
is canceled. Select [End].
The error cords are as follows.
01: The amount of data that can be
saved at once has been exceeded.
Turn the power OFF/ON. If the
error still occurs, divide the file into
smaller files. If the error occurs
after the file is divided, the
specified file may be damaged.
Delete the file.
04: Insufficient space on SSD to
complete this operation. Move data
or delete unneeded data.
Please be aware that when you
carry out initialization of the
system, the data saved in SSD
will be erased.
-
Staple jam. - If a staple jam occurs, the machine
will stop and the location of the jam
will be indicated on the screen.
Leave the machine on and follow
the instruction to remove the
jammed staple.
-
System error. - System error has occurred. Follow
the instructions on the screen.
-
Error Message Checkpoints Corrective Actions Reference
Page
The cover is open. Is there any cover which is
open?
Close the cover indicated on the
screen.
-
Is the top cover of the document
processor open?
Close the document processor
cover.
-
The device cannot
be connected
because allowed
connections would
be exceeded.
Are three handheld devices connected
simultaneously?
Cancel a connection to a portable
device that is not being used, or set
the machine's auto disconnect time
to break portable device
connections.
-
The manufacturer
assumes no
responsibility for
damage caused by a
non-genuine toner.
Is the installed toner container our own
brand?
We will not be liable for any
damage caused by the use of third
party supplies in this machine. If
you want to continue, select [Next
>].
10-4
The phone receiver
is off the hook.
- Put down the receiver. -
The SD Card is not
formatted.
Is the SD Card formatted by this
machine?
Select [Format] from [Common
Settings], under [System Menu].
-
Error Message Checkpoints Corrective Actions Reference
Page
To Next Page
Loading...
Need help?
General
