11-23
Troubleshooting > Responding to Messages
1105 Failed to send via SMB. Check the following settings.
[System Menu / Counter] key > [Function Key
Assignment] > [Menu] > [Store File] > [Quick Setup
Wizard] >
[SMB Client (Transmission)]
5-16
Failed to send the e-mail. Select [Submit] of the SMTP settings on the Command
Center RX.
2-45
Failed to send via FTP. Check the following settings.
[System Menu / Counter] key > [Function Key
Assignment] > [Menu] > [Store File] > [Quick Setup
Wizard] >
[Function Type]
5-18
1106 Failed to send the e-mail. Check the sender address of SMTP on the Command
Center RX.
2-45
1131 Failed to send via FTP. Enable the SSL.
[System Menu / Counter] key > [Function Key
Assignment] > [Menu] > [Report] > [Print]
5-18
1132 Failed to send the e-mail. Check the following of the SMTP server.
• Is SMTP over SSL available?
• Is the encryption available?
Refer to the
Command
Center RX
User Guide.
Failed to send via FTP. Check the following of the FTP server.
• Is FTPS available?
• Is the encryption available?
—
2101 Failed to send via SMB. Check the network and SMB settings.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• Host name and IP address
• Port number
—
Failed to send via FTP. Check the network and FTP settings.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• Host name and IP address
• Port number
—
Failed to send the e-mail. Check the network and Command Center RX.
• The network cable is connected.
• The hub is not operating properly.
• The server is not operating properly.
• POP3 server name of the POP3 user
• SMTP server name
2-45
Error
Code
Message Corrective Actions Reference
Page
To Next Page
Loading...
