5. Turn the front panel Wavepilot position knobs to adjust the vertical and horizontal position of
the zoom:
6. Turn the front panel Zoom knobs to control the boundaries of the zoom.
Zooming Multiple Waveforms Quickly
Press the QuickZoom button
on the front panel. Math function traces F5 to F8 will be used
to create a zoom of each displayed input channel waveform. Each zoom will be displayed in its
own grid.
Turning Off Zoom
1. Touch the math function trace label for the zoom you want to turn off.
2. Touch the Trace On checkbox to delete the check mark and disable the zoom trace.
Multi-Zoom
The Multi-zoom feature creates time-locked zoom traces for only the waveforms that you choose
to include. The zooms are of the same X-axis section of each waveform. Thus, as you scroll
through a waveform, all included zooms scroll in unison.
Setting Up Multi-zoom
1. In the menu bar, touch Math, then Math Setup... in the drop-down menu.
2. Verify that the math function selected for each Fx position you want to include is zoom. If you
need to change the math function for any Fx position, simply touch the Fx button and select
Zoom from the Select Math Operator menu.
3. Touch the On checkbox to display each zoom you want to include in the multi-zoom.
4. Touch the Multi-Zoom Setup button. The Multi-Zoom dialog opens.
104 SDA-OM-E Rev H
To Next Page
Loading...
Need help?
General