Turning on a Channel Trace Label
Note: If you want to display each trace on its own grid automatically, enable Autogrid by touching Display in the menu
bar, then Autogrid in the drop-down menu.
• On the front panel, press a channel select button, such as , to display the trace label for
that input channel and turn on the channel.
• To turn on a math function trace, touch Math in the menu bar, then Math Setup... in the drop-
down menu. Touch the On checkbox for the trace you want to activate.
• You can also quickly create traces (and turn on the trace label) for math functions and
memory traces, without leaving the Vertical Adjust dialog, by touching the icons at the bottom
of the Vertical Adjust dialog:
Whenever you turn on a channel, math, or memory trace via the menu bar, the dialog at the
bottom of the screen automatically switches to the vertical setup or math setup dialog for that
selection.
You can configure your traces from here, including math setups.
The channel number appears in the Vertical Adjust tab of the "Vertical Adjust" dialog, signifying
that all controls and data entry fields are dedicated to the selected trace.
52 SDA-OM-E Rev H
To Next Page
Loading...