SDA Operator’s Manual
Help Marker Setup
1. In the menu bar, touch Measure Setup...
2. Select a Measure Mode: Std Vertical, Std Horizontal, or My Measure.
3. Touch the Show All button
to display Help Markers for every parameter
being measured on the displayed waveform (C2 in the examples above).
4. Touch a P1 to Px tab
for any parameter listed; it doesn't matter which. Touch
inside the Help Markers field and select Simple The Simple selection produces cursors and
Measure Gate gate posts. The gate posts are independently placeable for each parameter. or
Detailed The Detailed selection produces cursors, Measure Gate gate posts, a label
identifying the parameter being measured, and a level indicator and hysteresis band for "at
level" parameters.
Note: The choice of Simple or Detailed is applied to all parameters at the same time. That is, if you choose Simple
markers for one parameter, all parameters will be displayed in this mode.
5. Touch the Always On checkbox if you want to continuously display Help Markers for this
parameter.
Turning Off Help Markers
1. Touch the Clear All button
to turn off Help Markers for all parameters.
2. To turn off Help Markers for individual parameters, touch the Px tab for the parameter in
question. Then uncheck the Always On checkbox. When you close this dialog, the Help
Markers for this parameter will no longer be displayed.
Customizing a Parameter
From the Measure Dialog
1. Touch the My Measure button in the "Measure" dialog. The dialog presents you with a panel
of eight preset parameters.
2. For each parameter, touch the On check box to enable the parameter listed.
SDA-OM-E Rev H 149
To Next Page
Loading...