SDA Operator’s Manual
Example Setups
FSBEyeModeConfiguration
ChannelSetup
• DataStrobep: Channel 1 (M1)
• DataStroben: Channel 2 (M2)
• Data1: Channel 3 (M3)
• Data2: Channel 4 (M4)
SerialDataAnalysisSetup
1. Select Signal Type: FSB 533MHz, 667MHz or 800MHz
2. Uncheck Recover Clock - No clock recovery is required in FSB case
3. Select Eye Diagram Tab, then configure the screen as follows:
• Mode: FSB
• Data Source 2: Channel 4 (M4)
• DSTBP: Channel 1 (M1)
• DSTBN: Channel 2 (M2)
The screen should look like this:
SDA-OM-E Rev H 357
To Next Page
Loading...