SDA Operator’s Manual
The initial dialog for the wizard gives you an overview of wizard operation. This dialog can be
disabled after the first use of the wizard by checking the “Don’t show me this message again”
checkbox. In this case, the dialog will not be displayed until the instrument is restarted.
The remainder of the jitter setup wizard guides you through a series of dialogs that request input
concerning the signal type and measurement method that is desired. Explanations of the various
choices that can be made are also provided.
Each dialog has a default selection that represents the most common configuration. You can
accept the defaults by simply touching the Next button in each dialog.
SDA-OM-E Rev H 311
To Next Page
Loading...
Need help?
General