Lenze 8400 - Overlay Function

10 Oscilloscope function
10.3 Managing oscillograms
698
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
10.3.4 Overlay function
The overlay function serves to lay several characteristics from the currently loaded oscillogram files
on top of each other, e.g. to compare signal characteristics from different recordings.
• If two or more oscillograms are loaded in the oscilloscope, e.g. the device oscillogram and an
oscillogram previously saved in the project, a "MERGE" tab is available.
• If the MERGE tab is selected, the desired characteristics to be overload or compared can be
selected from the loaded files in the channel list.
• If a device oscillogram is used in the merge tab, an update is carried out in the MERGE
oscillogram in case of a renewed recording.
• Removing signal sources from the device oscillogram causes the characteristics in the MERGE
oscillogram to be deleted.