EasyManua.ls Logo

Lenze 8400 - User Menu for Quick Access to Frequently Used Parameters

Lenze 8400
1590 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 41
2 Introduction: Parameterising the inverter
2.3 General notes on parameters
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.3.4 User menu for quick access to frequently used parameters
When a system is installed, parameters must be changed time and again until the system runs
satisfactorily. The user menu of the inverter contains a selection of frequently used parameters to
be able to access and change these parameters quickly:
Tip!
The user menu can be freely configured in C00517
.
In the »Engineer«, you can configure the user menu comfortably via the User menu tab (see
»Engineer« online help).
The password protection
serves to restrict the access to parameters of the user menu. Then,
all other parameters cannot be accessed without knowing the password and are thus
protected against unwanted changes.
Parameters Name Lenze setting
C00051 MCTRL: Actual speed value -
C00053 DC-bus voltage -
C00054 Motor current -
C00061 Heatsink temperature -
C00137 Device status -
C00166/3 Mess. - status det. error -
C00011 Appl.: Reference speed 1500 rpm
C00039/1
Fixed setpoint 1 40.00 %
C00039/2
Fixed setpoint 2 60.00 %
C00012 Acceleration time - main setpoint 2.000 s
C00013
Deceleration time - main setpoint 2.000 s
C00015
VFC: V/f base frequency 50 Hz
C00016
VFC: Vmin boost 1.60 %
C00022
Imax in motor mode depending on the device power
C00120
Setting of motor overload (I
2
xt) 100.00 %
C00087
Rated motor speed 1460 rpm
C00099 Firmware version -
C00200 Firmware product type -
C00105
Decel. time - quick stop 2.000 s
C00173
Mains voltage 0: "3ph 400V / 1ph 230V"
Greyed out = display parameter

Table of Contents

Other manuals for Lenze 8400

Related product manuals