Lenze 8400 - Application Blocks

Lenze · 8400 HighLine · Reference manual · DMS 12.0 EN · 06/2017 · TD23 1560
17 Function library
17.3 Application blocks | Technology application "Actuating drive speed"
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
17.3 Application blocks
17.3.1 Technology application "Actuating drive speed"
This technology application serves to solve speed-controlled drive tasks, e.g. conveyor drives
(interconnected), extruders, test benches, vibrators, travelling drives, presses, machining systems,
metering units.
17.3.2 Technology application "actuating drive speed (AC Drive profile)"
This technology application available from version 13.00.00 provides a speed and torque control by
means of "AC Drive Profile". The fieldbuses EtherNet/IP™ and system bus (CANopen) are supported.
17.3.3 Technology application "Table positioning"
This technology application serves to solve position-controlled drive tasks which are normally
controlled by a higher-level control via a fieldbus, e.g. transport facilities, rotary tables, storage and
retrieval units, feed drives, metering units, hoists.
17.3.4 "Switch-off positioning" technology application
This technology application is used to solve speed-controlled drive tasks which require a pre-switch
off or stopping at certain positions, e.g. roller conveyors and conveying belts. The pre-switch off is
implemented by connecting switch-off sensors.
 For a detailed description see TA "Actuating drive speed". ( 374)
 For a detailed description see TA "actuating drive speed (AC Drive Profile)". ( 401)
 For a detailed description see TA "Table positioning". ( 434)
 For a detailed description see TA "Switch-off positioning". ( 464)