Lenze i510 - Page 228

Changing inverter sengs by means of the keypad (general operaon)
STOP
MAN AUTO SETLOC REM
GROUP 2
MAN AUTO SETLOC REM
Basic Setup
PAR 226
MAN AUTO SETLOC REM
S-Ramp Charact.
00
MAN AUTO SETLOC REM
P226/001
GROUP 0
MAN AUTO SETLOC REM
Favorites
PAR 200
MAN AUTO SETLOC REM
Start Control
15
MAN AUTO SETLOC REM
P226/001
1.
2.
3.
4.
5.
7.
8.
SUB 001
MAN AUTO SETLOC REM
Smooth Factor
6.
VEL:FLEX:AIN1
%
%
1.Use the key in the operang mode to naviga
te to the
parameterisaon mode one level below.
You are now in the group level.
Note: By using the
key you can navigate one level
upwards again anyme.
2.Use the and navigaon keys to select the desired
group.
3.Use the key to navigate to one level below.
You are now in the parameter le
vel of the group selec-
ted.
4.Use the
and navigaon keys to select the desired
paramet
er.
5.Use the
key to navigate to one level below.
If the parameter does not cont
ain any subindexes, you
are now in the eding mode (connue with step 7). Oth-
erwise you are in the SUB parameter level.
6.If the parameter contains subindexes:
a)Use the
and navigaon keys to select the
desired subindex.
b)
Use the
key to navigate to one level below.
You are now in the eding mode.
7.Set the desir
ed value using the
and navigaon
keys.
8.Use the key to accept the changed seng.
The eding mode is exited.
Note: B
y using the
key you can exit the eding mode
without accepng the new seng (abort).
The SET display is blinking if a parameter seng has been changed but has not
been saved in the memory module with mains failur
e protecon. In order to
save parameter sengs in the user memory of the memory module, press the
keypad "Enter" key > 3 s.
Appendix
Changing the parameter sengs using the k
eypad
228
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.actechdrives.com - Email: info@actechdrives.com