Chapter 10 Automated Devices
Page 172 Rev. 1.30.03.07.r1
Creating a new DDL in the Console
The procedure below gives the general steps for defining a new device
within the control console:
Procedure: Notes:
1. Press [SETUP] Opens Setup display
2. Press (Device) Enters Device Assignment
sub-display
3. Press [4] Device menu item 4:
"Add Definition"
4. Enter new device name Use the submaster bump
buttons for letters
5. Press [ENTER]
6. Use the Definition menu to modify or See Table 10.4 below
insert traits accordingly.
7. Use arrow keys to highlight the
trait attribute and select [ENTER] to edit.
8. Press [CLEAR] to return to previous screen.
Follow the example steps below to define a new device and add it to the
device library (a simple fog machine using one trait is used in this
example):
Procedure: Notes:
1. Press [SETUP] Opens Setup display
2. Press (Device) Enters Device Assignment
sub-display
3. Press [4] Device Menu item 4:
"Add Definition"
4. Enter [F] [O] [G] Use the sub bump buttons for
letters for device name "FOG"
5. Press [ENTER]
6. Press [4] Definition Menu item 4:
(see Table 10.4 below) "Insert Continuous"
7. Use up/down arrow keys to select
"Special" from Trait name popup list
8. Press [ENTER] Device Defined
Press [CLEAR] to exit
To Next Page
Loading...
