Action Yes No
Step 5
Check the MPF lift plate solenoid, including the actuator for wear or
damage, and replace if necessary. See
“MPF lift plate solenoid removal”
on page 301.
Does the problem remain?
Go to step 6. The problem is solved.
Step 6
Observe the MPF lift plate clutch.
Is it working properly?
Go to step 8. Go to step 7.
Step 7
a Reseat the MPF lift plate clutch cable.
b Check the cable for damage, and replace if necessary.
Does the problem remain?
Go to step 8. The problem is solved.
Step 8
Check the MPF lift plate clutch for damage, and replace if necessary.
Does the problem remain?
Go to step 9. The problem is solved.
Step 9
Check the sensor (MPF lift plate).
Is it free of damage?
Go to step 10. Go to step 12.
Step 10
Enter the Diagnostics menu, and then navigate to:
SENSOR TESTS > PRINTER SENSOR TESTS > MPF lift plate position
Does the sensor status change while toggling the sensor?
Go to step 13. Go to step 11.
Step 11
a Reseat the MPF lift plate sensor cable.
b Check the cable for damage, and replace if necessary.
Does the problem remain?
Go to step 12. The problem is solved.
Step 12
Replace the sensor (MPF lift plate). See
“Sensor (MPF lift plate) removal”
on page 303.
Does the problem remain?
Go to step 13. The problem is solved.
Step 13
Enter the Diagnostics menu, and then navigate to:
MOTOR TESTS > PRINTER MOTOR TESTS > Paper feed
Does the motor run?
Go to step 17. Go to step 14.
7421
Diagnostic information
168
To Next Page
Loading...
