3 Open the bottom front door and right door.
4 Select Registration.
5 Press X three times.
6 Close the bottom front door and right door.
Note: If the engine does not initialize, then the motor test is in safe mode.
7 Select a motor.
8 Check if the motor runs.
Note: Not all motors run the same way.
The following motors run, and then stop after a preset duration:
• MPF tray lift-up plate elevator down
• Tray 1 lift
• Tray 2 lift
• Fusing pressure release
The following motors continuously run, unless the test is canceled:
• Registration
• Paper feed
• Tray 2 vertical transport
• Polygon
• Transport
• Fusing
• Developing
• Duplex transport
• Redrive forward
• Redrive reverse
2x500‑Sheet Tray Motor Tests
These tests verify that the 2 x 500‑sheet tray motors are properly working.
Note: If these tests are not performed in safe mode, then the control panel may become unresponsive.
1 Enter the Diagnostics menu, and then close the bottom front door.
2 Navigate to:
Motor Tests > PRINTER MOTOR TESTS
3 Open the bottom front door and right door.
4 Select Registration.
5 Press X three times.
6 Close the bottom front door and right door.
Note: If the engine does not initialize, then the motor test is in safe mode.
7421
Service menus
220
To Next Page
Loading...
