Lexmark MX912dxe - Page 66

Action Yes No
Step 3
Check the registration sensor actuator for damage, and replace if
necessary.
Does the problem remain?
Go to step 4. The problem is solved.
Step 4
Check the sensor (registration).
Is it free of damage?
Go to step 5. Go to step 7.
Step 5
Enter the Diagnostics menu, and then navigate to:
SENSOR TESTS > PRINTER SENSOR TESTS > Registration
Does the sensor status change while toggling the sensor?
Go to step 8. Go to step 6.
Step 6
a Reseat the registration sensor cable.
b Check the cable for damage, and replace if necessary.
Does the problem remain?
Go to step 7. The problem is solved.
Step 7
Replace the sensor (registration).
Does the problem remain?
Go to step 8. The problem is solved.
Step 8
Enter the Diagnostics menu, and then navigate to:
INPUT TRAY TESTS > Feed Tests > Tray 1
Does the leading edge of the paper reach the sensor (registration)?
Go to step 10. Go to step 9.
Step 9
Check the tray 2 transport roller for damage, and replace if necessary.
Does the problem remain?
Go to step 10. The problem is solved.
Step 10
Check the registration roller for wear or damage, and replace if necessary.
Does the problem remain?
Go to step 11. The problem is solved.
Step 11
Enter the Diagnostics menu, and then navigate to:
MOTOR TESTS > PRINTER MOTOR TESTS > Registration
Does the motor run?
Go to step 15. Go to step 12.
7421
Diagnostic information
66