Malfunctions in driving mode
8.6 Tilting/lowering the driver's cab
8 - 46 3 302 736 en Operating manual
GMK4090
xx.xx.xxxx
• Continue to pump until the driver's cab tilts no further.
• Secure the driver's cab – fold out the fall-back guard strut (1).
Lowering the
driver's cab
• Fold down the fall-back guard strut (1).
• Check that the lever is pointing (2) backwards (B).
• Use the lever to pump (1) – the driver's cab is lowered.
• Lower the driver's cab to its end position – the lock closes audibly.
• Switch on the ignition and check that the symbol (1) has gone out.
• If necessary, lower the driver's cab further until the symbol (1) goes out.
G
Risk of accidents due to the driver's cab tilting back.
You may only stand under the tilted driver's cab if the fall-back guard strut
is folded out.
To Next Page
Loading...
