Rigging work
12.9 Rigging/unrigging the counterweight
12 - 86 3 302 736 en Operating manual
GMK4090
xx.xx.xxxx
3.4 t installed to the turntable
• Secure the 2.9 t plate using suitable lifting
gear so that the plate cannot fall down dur-
ing removal;
à Slinging points on the coun-
terweight sections
, p. 12 - 75
• Remove all bolts (1).
• Lift off the 2.9 t plate.
Version B
9.1 t at the turntable
• Use automatic mode to lift the 9.6 t counter-
weight combination onto the turntable;
à Automatic mode rigging, p. 12 - 108.
• Turn the nuts (1) up so far that you can lift
the locking bar (2) over the stop (3).
• Lift the locking bar (2) over the stop (3) and
remove the bracket (4) from the slinging
point (5).
• Remove the bracket on the other side in the
same way.
• Use automatic mode to lower the counter-
weight combination onto the turntable.
To Next Page
Loading...
