Rigging work
12.9 Rigging/unrigging the counterweight
Operating manual 3 302 736 en 12 - 87
GMK4090
xx.xx.xxxx
6.8 t at the turntable
• Use automatic mode to lift the 11.5 t coun-
terweight combination onto the turntable;
à Automatic mode rigging, p. 12 - 108.
• Turn the nuts (1) up so far that you can lift
the locking bar (2) over the stop (3).
• Lift the locking bar (2) over the stop (3) and
remove the bracket (4) from the slinging
point (5).
• Remove the bracket on the other side in the
same way.
• Use automatic mode to lower the counter-
weight combination onto the turntable.
4.5 t at the turntable
• Secure the 4.0 t plate using suitable lifting
gear so that the plate cannot fall down dur-
ing removal;
à Slinging points on the coun-
terweight sections
, p. 12 - 75
• Remove the bolts (1).
• Lift off the 4.0 t plate.
s
To Next Page
Loading...
