Rigging work
12.9 Rigging/unrigging the counterweight
Operating manual 3 302 736 en 12 - 89
GMK4090
xx.xx.xxxx
8.0 t at the turntable
• Use automatic mode to lift the 7.3 t 10.8 t
counterweight combination onto the turnta-
ble;
à Automatic mode rigging, p. 12 - 108.
• Push the locking bar (2) up to the nuts (1).
• Suspend the bracket (4) on the slinging
point (5) from below.
• Fold the bracket on the 2.9 t counterweight
section in such a way that the locking bar is
behind the stop (3).
• Tighten the nuts (1) enough so that the
bracket is at the stop and has no more play.
Check the connection after the first on-road
drive.
• Secure the bracket on the other side in the
same way.
Use automatic mode to lower the counterweight combination onto the turn-
table.
Version B
4.5 t at the turntable
• Lift the 4.0 t plate onto the turntable with a
suitable lifting device;
à Slinging points on
the counterweight sections
, p. 12 - 75
• Fasten all bolts and nuts (1) with 1,800 Nm
(1,327 lb fft).
• Remove the lifting gear.
s
To Next Page
Loading...
