Rigging work
12.9 Rigging/unrigging the counterweight
12 - 90 3 302 736 en Operating manual
GMK4090
xx.xx.xxxx
6.8 t at the turntable
• Use automatic mode to lift the 11.5 t coun-
terweight combination onto the turntable;
à Automatic mode rigging, p. 12 - 108.
• Push the locking bar (2) up to the nuts (1).
• Suspend the bracket (4) on the slinging
point (5) from below.
• Fold the bracket on the 4 t counterweight
section in such a way that the locking bar is
behind the stop (3).
• Tighten the nuts (1) enough so that the
bracket is at the stop and has no more play.
Check the connection after the first on-road
drive.
• Secure the bracket on the other side in the same way.
• Use automatic mode to lower the counterweight combination onto the
turntable.
9.1 t at the turntable
• Use automatic mode to lift the 9.6 t counter-
weight combination onto the turntable;
à Automatic mode rigging, p. 12 - 108.
• Push the locking bar (2) up to the nuts (1).
• Suspend the bracket (4) on the slinging
point (5) from below.
• Fold the bracket on the 4 t counterweight
section in such a way that the locking bar is
behind the stop (3).
• Tighten the nuts (1) enough so that the
bracket is at the stop and has no more play.
Check the connection after the first on-road
drive.
• Secure the bracket on the other side in the same way.
• Use automatic mode to lower the counterweight combination onto the
turntable.
To Next Page
Loading...
