MIMAKI UJF-3042 - Page 206

© 2013 MIMAKI ENGINEERING CO.,LTD.
7.1.2 P.5
7.1.2 List of Error Messages
1
2
3
4
5
6
7
8
38
ERROR 511
Z ORIGIN
Z-origin error
(Origin of Z-axis can not be detected)
1. Execute and confirm [#TEST]->[SENSOR TEST]->
[TBL-ORG].
2. Check the connection of connector of the Z-origin
Sensor.
3. Replace the Z-origin Sensor with a new one.
4. Disconnect and connect the connector of the Z-
Motor(Stepping motor).
5. Replace the Station III PCB with a new one.
(Refer to 6.4.4)
39
ERROR 601
INK NEAREND
Ink near end (A small amount of ink left) (When the message is still displayed even after a new Ink
Cartridge or an empty Ink Cartridge is charged;)
1. Execute and confirm [#TEST]->[SENSOR TEST]->
[INK NEND1](The number meets the cartridge No.).
2. Check the peripheral and the assembly of the End
Sensor.
3. Check the connection of the Presence Sensor and the
Near End Sensor.
4. Replace the Cartridge with a new one
5. Replace the Presence/Near End Sensor with a new
one.
6. Replace the SL-Relay PCB with a new one.
(Refer to 3.3.2)
7. Replace the Main PCB with a new one. (Refer to 3.3.1)
40
ERROR 602
INK END
Ink end (No ink left) (If this message appears when a new cartridge or a
cartridge with enough ink is set)
1. Execute and confirm [#TEST]->[SENSOR TEST]->
[INK NEND1](The number meets the cartridge No.).
2. Check the peripheral and the assembly of the End
Sensor.
3. Check the connection of the Presence Sensor and the
End Sensor.
4. Replace the Cartridge with a new one.
5. Replace the Presence / Near End Sensor with a new
one.
6. Replace the SL-Relay PCB with a new one.
(Refer to 3.3.2)
7. Replace the Main PCB with a new one. (Refer to 3.3.1)
41
ERROR 603
NO CARTRDG
No cartridge (Cartridge is not installed) (When the message is still displayed even after a Ink
Cartridge is charged;)
1. Execute and confirm [#TEST]->[SENSOR TEST]->
[INK1](The number meets the cartridge No.)..
2. Check the peripheral and the assembly of the Presence
Sensor.
3. Check the connection of the Presence Sensor and the
End Sensor
4. .Replace the Cartridge with a new one
5. Replace the Presence/Near End Sensor with a new
one.
6. Replace the SL-Relay PCB with a new one.
(Refer to 3.3.2)
7. Replace the Main PCB with a new one. (Refer to 3.3.1)
 List of Error Messages (5/9)
No. LCD Cause List of Countermeasures
R.2.0
Maintenance Manual > Troubleshooting > Details on Errors and Malfunctions > List of Error Messages
Model UJF-3042/FX Issued 2010.08.27 Revised 2011.09.30 F/W ver 1.80 / 1.00 Remark
2.0
Rev.