© 2013 MIMAKI ENGINEERING CO.,LTD.
7.1.2 P.6
7.1.2 List of Error Messages
1
2
3
4
5
6
7
8
42
ERROR 605
!CLEANING WIPER
Wiper lifetime
(Wiping times exceeding the specified
number.)
1),Wiping times
(Ink parameter 1 No45 WipeCnt)
Wiping time is cleared when the
following is executed:
[FUNCTION MAINTENANCE]-
>[STATION]->[MENT:WIPER
EXCHG]
2),Specified number :Wiper life
(Ink parameter 2 No58 WIPElmt) x
Wiper replacement level
1. Execute [FUNCTION MAINTENANCE]-
>[STATION]->[MENT:WIPER CLEANING] to clean
the wiper.
2. Replace the Main PCB with a new one. (Refer to 3.3.1)
43
ERROR 606
WRONG CARTRIDGE
The IC chip of the ink cartridge is not read
properly.
(If this message appears when a correct cartridge is set)
1. Check the assembly of the ID Contact PCB and the
shape of the contact plate, and execute the cleaning.
2. Check the connection of the ID Contact PCB.
3. Replace the Cartridge with a new one
4. Replace the ID Contact PCB Assy. with a new one.
(Refer to 3.3.3)
5. Replace the SL-Relay PCB with a new one.
(Refer to 3.3.2)
44
ERROR 607
CAP CLEANING
Warning for cleaning around the cap
(A specified number of flushing on the
cap exceeded.)
1),
Capcleaning counter
(Ink parameter 1 No04 CapClean)
Counter is cleared when the following
is executed:
[FUNCTION MAINTENANCE]-
>[STATION]->[MENT:CARRIAGE
OUT]
2),Specified number of the Capcleaning :
warning leve
l
100x2^(Ink parameter 2 No.66
Cap.LM -1)
1. Clean the cap.
(If this message appears after cleaning the cap)
2. Replace the Main PCB with a new one. (Refer to 3.3.1)
45
ERROR 608
CARTRIDGE
Ink is tried to fill with unusable cartridge
installed.
1. Check the type of the ink cartridge.
Execute the followings if the type of the ink cartridge is
correct.
2. Check the assembly of the ID Contact PCB and the
shape of the contact plate, and execute the cleaning.
3. Check the connection of the ID Contact PCB.
4. Replace the Cartridge with a new one
5. Replace the ID Contact PCB Assy. with a new one.
(Refer to 3.3.3)
6. Replace the SL-Relay PCB with a new one.
(Refer to 3.3.2)
46
ERROR 60b
WIPER BOTTLE
Wiper bottle warning
A great deal of ink is in the Wiper Bottle.
Displayed when the Wiper Nozzle
Suction Pump exceeds the 2,500 times
[Fixed].
Wiper Pump suction times:
Ink parameter 1 No47 [Wipe Pump ]
1. Select [FUNCTION MAINTENANCE]->[STATION]-
>[MENT:WIPER BOTTLE] and dispose of ink in the
Wiper Bottle.
List of Error Messages (6/9)
No. LCD Cause List of Countermeasures
R.2.0
Maintenance Manual > Troubleshooting > Details on Errors and Malfunctions > List of Error Messages
Model UJF-3042/FX Issued 2010.08.27
Revised
2011.09.30
F/W ver
1.80 / 1.00
Remark
2.0
To Next Page
Loading...
