MIMAKI UJF-3042 - Page 25

© 2012 MIMAKI ENGINEERING CO.,LTD.
1.3.1 R.2.0 P.1
1
2
3
4
5
6
7
8
1.3.1 Monitoring of the Amount of Remaining Ink
 Outline
This printer supports both 220cc and 600cc cartridges.
This section describes how to monitor the amount of remaining ink.
 Monitoring the amount of remaining ink in 220cc cartridges
 Monitoring the amount of remaining ink in 600cc cartridges
No. Message Contents
1 (No message)  Indicates that the amount of ink remaining in the cartridge is between INK FULL and
INK NEAR END.
2 INK NEAR END  Occurs when the near end plate on the cartridge is ejected, and blocks the near end
sensor inside the slot.
 Cleaning and ink filling are not possible, and the head returns to local after each print
job.
 INK NEAR END status does not go off once it has been triggered.
3INK END  Occurs if 20cc is consumed after INK NEAR END.
 Cleaning, ink filling, and printing are not possible. (Remote migration is not possible.)
 INK NEAR END status does not go off once it has been triggered.
No. Message Contents
1 (No message)  Indicates that the amount of ink remaining in the cartridge is between INK FULL and
30cc.
2 INK NEAR END  Occurs if the amount of ink remaining is 60cc or less.
 Cleaning, ink filling, and printing are not possible.
 This status goes off when the cartridge weight is entered.
 However, at 30cc or less INK NEAR END occurs, and at 25cc or less INK LEVEL
END occurs.
3INK END  Occurs if the amount of ink remaining is 30cc or less.
 Cleaning and ink filling are not possible, and the head returns to local after each print
job.
 INK NEAR END status does not go off once it has been triggered.
4 INK LEVEL END  Occurs if the amount of ink remaining is 25cc or less.
 Cleaning, ink filling, and printing are not possible.
 This status switches to INK NEAR END when the cartridge weight is entered and the
amount of ink remaining is 25cc or more.
 This status does not go off if the amount of ink remaining is 25cc or less.
Maintenance Manual > Operating Principle > Ink System > Monitoring of the Amount of Remaining Ink
Model
UJF-3042/FX
Issued
2013.07.18
Revised F/W ver
1.80 / 1.00
Remark
2.0
Rev.