10 Display & Cine Review
Operator’s Manual 10 - 3
For B/B+Color/B+Power mode, bottom-left corner will indicate current frame and total frames.
For B/B+M/B+PW mode, bottom-left corner will indicate time played and total time.
Manual Cine Review
After entering cine review in 2D mode, drag playback mark to review the cine images on the screen
one by one.
Drag the playback mark to the left to display the earlier stored images; drag the playback mark to
the right to display the recently stored images.
Or, swipe the image area to the right to display the earlier stored images; swipe the image area to
the left to display the recently stored images.
Reviewing all of Auto Review
Perform the following procedure:
1. In manual cine review status, tap to activate auto cine review.
2. Review speed: in auto cine review status, tap to select different speeds.
3. In auto play status, tap to stop auto play.
Setting scope of Auto Review
You can set a segment of cine loop which can be reviewed automatically. After the auto review
region is set, the auto cine review can only be performed within this region; but the manual cine
review can be performed beyond this region. When the cine file is saved, only the images within
this scope are saved.
Perform the following procedure:
1. Set first frame: drag the start mark to the frame as start point.
2. Set end frame: drag the end mark to the frame as end point.
3. Tap to start play and select the speed.
4. Tap to end auto play.
1 Start mark
2Playback mark
3End mark
4 Auto Review Region
To Next Page
Loading...
Need help?
General
