Operator’s Manual 17 - 1
17 System Maintenance
Routine system maintenance shall be carried out by the user. System maintenance after the
warranty has expired is the full responsibility of the owner/operator.
The responsibility for maintenance and management of the product after delivery resides with the
customer who has purchased the product.
If you have any questions, please contact Mindray Customer Service Department or sales
representative.
• Only an authorized Mindray service engineer can perform maintenance not
specified in this operator’s manual.
• For the sake of the system performance and safety, you should perform
periodical checks for the system.
17.1 Daily Maintenance
You are responsible for daily maintenance.
17.1.1 Cleaning the System
• Before cleaning the system, be sure to turn off the power and disconnect
the power cord from the outlet. If you clean the system while the power is
“On”, it may result in electric shock.
• DO NOT directly spray solution onto the monitor, system control panel or
hard surfaces that is under pressure or pumped. Ingress fluid leakage into
the monitor or system can damage the monitor or system, causing possible
electric shock or system failure.
Do not spill water or other liquid into the system while you perform the cleaning.
Otherwise it may result in malfunction or electric shock.
• DO NOT use hydrocarbon glass cleaner or cleaner for OA (Office Automation) equipment to
clean the monitor. These substances may cause deterioration of the monitor.