B Wireless LAN
Operator’s Manual B - 3
B.3 Troubleshooting
Operating frequency 2.412-2.472 GHz, 2.484 GHz
Channel spacing 5 MHz
Output power ≤17dbm
Wireless network mode Infrastructure, ad-hoc
Table B-2 Wireless Quality of Service:
Item Specifications
Data rate 802.11b: up to 11 Mbps @ 2.4 GHz
802.11g: up to 54 Mbps @ 2.4 GHz
802.11n: up to 300 Mbps @ 2.4 GHz and 5 GHz
Data security WPA2-PSK encryption
Application-layer reliability Application failure will be notified to the user
immediately.
System capacity No more than one device can be allowed to link
to the ultrasound system.
System anti-interference Can be coexistent with other Wi-Fi devices.
Network interruption alarm Network interruption is notified by
disconnection icon and failure in transmission is
notified by the dialog box.
EMC test process Wi-Fi function is not affected when the system
is imposed with radiation interference complied
with IEC60601-1-2:2014 standard.
Table B-1 Wireless specification and technology
Item Specifications
Failure Measure
Unable to connect the network. • Verify that network is available.
• The SSID and password of the device should
be consistent with those of the wireless AP.
• Check for IP address conflict. If yes, set the
IP address correctly.
• Check if Mindray recommended wireless
AP is used. If not, verify the AP effective
transmission rate meets the throughput
requirements of the connected devices.
To Next Page
Loading...
Need help?
General
