3 - 2 Operator’s Manual
3 System Preparation
• The battery is inside the machine. Only Mindray technical professionals or
engineers authorized by Mindray following training can perform battery
installation and uninstallation.
• If you need to change the battery or buy a new one, contact your sales
representative.
• The replacement of lithium batteries by inadequately trained personnel
could result in a HAZARD (such as excessive temperatures, fire or
explosion).
Battery Performance
When the system is working, the battery charges when its capacity is not full. The indicator turns
off when the capacity is full.
• Under power off or standby status, charging time of the battery from capacity 0 to 100% takes
less than 4 hours.
• The system lasts more than 22 hours in standby mode with full battery.
Power off the system if it will not be used for a long period of time (including storage/transportation
condition). Do not leave the system in standby status, otherwise the batteries will be discharged and
permanently damaged.
Battery specification
• Voltage: 14.8 V
• Capacity: 5800 mAh (single battery)
Battery Status Indicator
The battery status indicator is located in the top-right corner of the screen, indicating the battery
status.
• indicates charging status.
• indicates discharging status.
3.3 Power ON/OFF
To ensure safe and effective system operation, you must perform daily
maintenance and checks. If the system begins to function improperly,
immediately stop scanning. If the system continues to function improperly, fully
shut down the system and contact the Mindray Customer Service Department
or a sales representative. If you use the system in a persistent improperly
functioning state, you may harm the patient or damage the equipment.
To Next Page
Loading...
Need help?
General
