14 - 4 Operator’s Manual
14 DICOM/HL7
• When you begin an exam or send images during an exam, the system sends “Active” status
information to the MPPS server.
• When the exam is complete, the system sends “End” status information to the MPPS server.
• When a paused exam is continued, the system sends “Active” status information to the MPPS
server.
• When an exam is canceled, the system sends “Canceled” status information to MPPS server.
14.5 Storage Commitment
Storage commitment is used to confirm whether the images or structured reports are successfully
stored on the DICOM storage server.
Before using storage commitment, set the associated storage service.
If images are successfully sent to the storage server, in the iStation screen, “PACS received, OK” is
displayed in the list below “Storage Commitment”.
Multi-frame storage is not allowed if “Allow Multiframe” is not selected (For details,see
“4.3.2 DICOM Service Preset”). For example, even if there is a multi-frame file in the exam to be
sent, only single-frame image storage will be performed.
14.5.1 After sending images on the iStation screen
Perform the following procedure:
1. Open the iStation screen.
2. Select an exam (a suspended exam or an inactive exam) (images are stored in the exam
record).
3. Tap [Send To] to open the Send To dialog box.
4. Tap to select “DICOM” in the Target box on the left side, then select the DICOM storage
server in the Choose Storage Server box on the right side.
5. Tap [Send] to start sending. The system will send all the images stored in the exam record to
the storage server. Meanwhile, it will send storage commitment to the storage commitment
server.
14.5.2 Storage commitment after an exam ends
Perform the following procedure:
1. Preset Sending/printing after End Exam, for details see “4.1.2 General”.
2. Set the default storage server and storage commitment server.
For details, see “4.3.2 DICOM Service Preset”.
3. After finishing the presets, perform image scanning. Each time [End] is tapped, the system will
send the image to the default DICOM storage server for storage and send storage commitment
to the storage commitment server.
Storage commitment is confined to the whole exam. Not each image sending can be indicated.
14.6 Query/Retrieve
The query/retrieve function is used to query and retrieve patient exam records in a designated
server.
To Next Page
Loading...
Need help?
General
